Fulgor Milano F7DMW24S1 Installation Manual
DRAWER MICROWAVE
INSTALLATION GUIDE
GUIDE D’INSTALLATION
EN
Installation GuideInstallation Guide
Special Warning
INSTALLATION AND SERVICE MUST BE PERFORMED BY
A QUALIFIED INSTALLER.
IMPORTANT: SAVE THIS INSTALLATION MANUAL FOR
LOCAL ELECTRICAL INSPECTOR’S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
Clearances and Dimensions
For SAFETY CONSIDERATIONS do not install drawer in
any combustible cabinetry, which is not in accordance
with the stated clearances and dimensions on pages 3 - 5.
See Figures 1 - 7.
Unpacking Your Drawer Microwave
• Remove all packing materials from inside the drawer.
DO NOT REMOVE THE WAVEGUIDE COVER, which is
located on the ceiling of the microwave cavity.
• Check the drawer for any damage, such as misaligned
or bent drawer, damaged drawer seals and sealing
surfaces, broken or loose drawer guides and dents inside
the cavity or on the front side of the drawer. If there is any
damage, do not operate the microwave and contact your
dealer or a FULGOR MILANO AUTHORIZED SERVICER.
Sealing
Surface
Waveguide
Cover
Important Notes to the Consumer
Keep this manual with your Use & Care Manual for future
reference.
• As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use & Care Manual. Read all and
follow carefully.
• Be sure your Drawer Microwave is installed and
grounded properly by a qualified installer or service
technician.
Important Safety Instructions
WARNING If the information in this manual is not followed
exactly, a fire or electrical shock may result that could cause
property damage, personal injury or death.
WARNING To reduce the risk of tipping, the Drawer
Microwave must be secured by a properly installed AntiTip block.
• This Drawer Microwave must be electrically grounded
in accordance with local codes.
• Make sure the wall coverings and the cabinets around
the Drawer Microwave can withstand the heat generated
by the appliance.
WARNING - Never leave children alone or unattended in
the area where a Drawer Microwave is in use. Never leave
the drawer open when the microwave is unattended.
WARNING - Stepping, leaning or sitting on the drawer
may result in serious injuries and can also cause damage
to the Drawer Microwave.
• Do not use the Drawer Microwave as a storage space.
This creates a potentially hazardous situation.
• Check that the time-of-day is in the display. If not,
touch STOP/CLEAR for safety reasons and to prevent
unintended use.
Sealing
Surface
Oven
Cavity
Important Notes to the Installer
• Read all of the Installation Manual before installing the
Drawer Microwave.
• Remove all packing material before connecting the
electrical supply.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
2
Clearances and Dimensions
• Dimensions that are shown in Figure 1 must be used.
Given dimensions provide minimum clearance. Locate
electrical outlet in the shaded area in the upper left-hand
corner of the cutout. See Figure 9.
• Contact surface must be solid and level. Pay special
attention to the floor on which the Drawer Microwave
will sit. The floor of the opening should be constructed
of plywood strong enough to support the weight of
the oven (about 100 lbs/45 kg).
• Check location where the Drawer Microwave will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself
or under a gas or electric wall oven.
• Be sur
e that the clearance of the floor between the
wall oven and the Drawer Microwave is a minimum of
2" (5 mm).
Installation Guide
B
C
G
D
A
F
E
EN
• The microwave interior will easily accommodate a
9” x 13” oblong dish or a bag of microwave popcorn.
• The oven can also be mounted flush. Please see
instructions for flush mounting.
Standard Mount and Measurements
A
6" (152.4 mm)
B
Suggested electrical outlet location*
C
Anti-Tip block
D
5" (127 mm)
1
E
⁄2" (89 mm)
3
F
4" (101.6 mm)
1
G
H
J
K
⁄8" (562 mm) opening
22
13
⁄16" (376.3 mm) to bottom of Anti-Tip block
14
I
7
Allow
23
Allow
⁄8" (22.2 mm) overlap
1
⁄2" (597 mm) minimum depth
7
⁄16" (11 mm) overlap
5
⁄8” (549.3 mm)
21
A
11
⁄16” (119 mm)
4
B
3
⁄4” (44.5 mm)
1
C
7
⁄8” (555.6 mm)
21
D
5
⁄8” (600.1 mm)
23
E
16” (406.4 mm)
F
5
⁄8” (370.7 mm)
14
G
9
H
⁄16” (39 mm) door thickness
1
I
15” (381 mm) auto drawer opening
J
4” (101.6 mm)
B
C
F
A
J
G
I
L
36" (914.4 mm) countertop height
M
N
O
P
M
L
7
Allow
⁄16" (11 mm) minimum space
Floor must support 100 lb (45 kg)
24" (610 mm) cabinet minimum
9
⁄16" (395.3 mm) opening
15
B
D
F
G
I
J
D
H
E
Figure 2
A
C
E
Figures 1 and 2 contain measurements for reference when
planning the drawer’s location.
This Drawer Microwave can be installed below any radiant,
K
I
H
P
N
gas or induction cooktop and electric or gas wall oven.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum 1
1
⁄2" (38 mm) diameter
hole and deburred of all sharp edges.
IMPORTANT Always allow sufficient power cord length to
the electrical outlet to prevent tension.
Always check electrical codes for requirements.
O
Figure 1
3
EN
Move oven location downward for
Installation Guide
Figure 3 represents a typical standard cabinet. If installed
in custom cabinets with extended countertops, take into
account visibility and access to controls. See Figure 4.
25" (635 mm)
A
1
⁄2" (12.7 mm) minimum
B
16" (406.4 mm)
C
36" (914.4 mm)
D
Control panel shown in open position
E
24” (609.6 mm)
F
1
G
E
⁄2” (876.3 mm)
34
B
C
D
A
G
Flush Mount and Measurements
Prepare cabinet opening as shown in Figures 5, 6, 7.
6" (152.4 mm)
A
Suggested electrical outlet location
B
Anti-Tip block
C
5" (127 mm)
D
1
⁄2" (89 mm)
3
E
4" (101.6 mm)
F
7
⁄8" (606.4 mm)
23
G
13
⁄16" (376.2 mm) to bottom of
14
H
Anti-Tip block
9
⁄16" (39 mm)
1
I
1
⁄2" (597 mm) minimum depth
23
J
1
⁄8" (562 mm)
22
K
9
⁄16" (39 mm) to front of shelf
1
L
1
⁄4" (413 mm) opening
16
M
Floor must support 100 lb (45 kg)
N
Figure 3
extended countertops
Extended countertops
Figure 4
B
D
F
F
I
G
K
L
J
A
C
E
H
M
N
Figure 5
4
Loading...