Fujitsu FMW43VA1 User Manual
VGAOut.fm Page 1 Monday, August 27, 2001 9:05 AM
Fujitsu PC Corporation
VGA Adapter
Installation Guide
FMW43VA1
For use with StylisticTM LT Pen Tablet PCs
INSTRUCTIONS
The VGA Adapter allows you to connect an external
monitor directly to your pen tablet without using a docking
device.
Note: In order to use an external monitor simultaneously
with the flat panel display, you must set it up from
either within the BIOS or using the display hotpad.
See your system user’s guide for more information.
On one side of the adapter is a plug which fits into the
system interface port (see Figure 1). On the opposite side of
the adapter is a port for a video connector (see Figure 2).
To install the adapter,
1. If the pen tablet is running, either suspend operation or
power down the system.
VGAOut.fm Page 2 Monday, August 27, 2001 9:05 AM
2. If the external monitor you wish to connect has power
applied, power it down.
3. Remove the plastic cover that is located over the system
interface port on the bottom edge of the pen tablet. Keep
the cover in a safe place for future reinstallat i on.
4. Plug the VGA Adapter into the system interface port.
The plug is keyed so that it will only fit when it is positioned properly (see Figure 3).
5. Insert the video plug into the video connector (see
Figure 2).
6. Restart the syst em and the external monitor.
To remove the adapter,
1. If the pen tablet is running, either suspend operation or
power down the system.
2. If the monitor you wish to disconnect has power
applied, remove power.
3. Pull the plug from the connector. Replace the plastic
cover over the system interface port.
4. Restart your syst em .
Note: When the VGA Adapter is attached to the pen
tablet, the tablet cannot be used in the compact desk
stand because the connector/cable assembly extends
too far from the bottom of the system. The system
should be held or laid flat when the VGA Adapter is
installed.
2
Loading...