Fujitsu C141-E238-01EN User Manual

MAX3147RC, MAX3073RC, MAX3036RC

HARD DISK DRIVES INSTALLATION GUIDE

CARE OF YOUR FUJITSU DRIVE

Careful handling and installation of your disk drive is paramount to the longevity of the unit. The internal mechanism of the drive can be seriously damaged if the casing is subjected to forces outside the environmental specifications. When transporting the drive, always use the original packing in which the drive was delivered to you, and avoid exposing the drive to extreme changes in temperature to minimize the risk of condensation.

Handling

1. Never drop the unit. Handle it with care.

2. Never move the disk drive while disks are spinning. Note that the disks spin when the drive is powered on and also immediately after

3. Never place the drive in the vicinity of equipment giving off strong magnetic fields, such as monitors, televisions, or loudspeakers.

4. Never use any cleaning agents or liquids on the drive.

5. Always use an antistatic mat and wrist strap when handling the drive. Hold the drive by the base casting and never touch the components

6. Never remove any labels from the drive or deface them in any way.

7. Never open the disk enclosure for any reason. Doing so will void any warranties.

8. Always pay close attention to the mounting specifications such as those for sway space and cooling. If the temperature difference

INSTALLATION

1. ORIENTATION

2. MOUNTING SCREW INSTALLATION

3. COOLING

4. BREATHING

5. CONNECTING

power off. Refer to the Start/Stop specification for your drive.

on the printed circuit board.

between the storage location and installation location exceeds 10°C, for temperature acclimation purposes, leave the drive in the new location for at least two hours before turning it on. This minimizes any risk of condensation forming on the drive.

The Drive needs NO preventative or periodic maintenance during its service life if properly used in an appropriate environment.

The drive can be installed flat on any of its six sides. Inclination from a vertical or horizontal plane should not exceed 5°.

When the mounting screw holes on the side of the drive are used, be sure to use the two pairs of outer holes. Do not use the center hole in conjunction with only one of the outer holes. The screws must not penetrate the drive by more than 5.0 millimeters. Impact caused by the electric driver must be within the device specifications.

Allow space above and below the drive to provide an adequate air flow. Fan cooling is recommended. The disk enclosure temperature measured at center of base cover (label side) should never exceed 60 °C. See Table 1.

Table 1. Reference value of airflow

Environmental temperature Required velocity of airflow

°C > 0.3 m/s

°C > 0.6 m/s

°C > 0.9 m/s

°C > 1.5 m/s

Never cover the vent hole displayed on the label with the arrow.

To avoid potential damage to the drive, make sure that connector type and orientation is correct.

CAUTION: Your warranty may be voided if the connector is damaged as a result of incorrect insertion.

FUJITSU LIMITED Storage Products Group 4-1-1 Kamikodanaka, Nakahara-ku, Kawasaki 211-8588, Kanagawa-ken, Japan

http://www.fujitsu.com/

C141-E238-01EN