FUJIFILM FinePix S9000, FinePix S9500 TROUBLESHOOTING GUIDE
/
DIGITAL CAMERA
FinePix S9000
S9500
TROUBLESHOOTING GUIDE
US/CA/EU/EG/EE/AS/CH/JP-Model
z THE COMPONENTS IDENTIFIED WITH THE MARK “
DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR SAFETY.
PLEASE REPLACE ONLY WITH THE COMPONENTS SPECIFIED ON THE SCHEMATIC
DIAGRAM AND IN THE PARTS LIST.
WARNING
” ON THE SCHEMATIC
z IF YOU USE PARTS NOT SPECIFIED, IT MAY RESULT IN A FIRE AND AN
ELECTRICAL SHOCK.
Ref.No.: ZM00604-400
FUJI PHOTO FILM CO., LTD.
Printed in Japan 2006. 01
FinePix S9000/S9500 TROUBLESHOOTING GUIDE
SAFETY CHECK-OUT
After correcting the original problem, perform the following
safety check before return the product to the customer.
1. Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire
board surface for solder splasher and bridges.
2. Check the interboard wiring to ensure that no
wires are “pinched” or contact high-wattage
resistors.
3. Look for unauthorized replacement parts,
particularly transistors, that were installed during
a previous repair. Point them out to the customer
and recommend their replacement.
4. Look for parts which, though functioning, show
obvious signs of deterioration. Point them out to
the customer and recommend their replacement.
5. Check the B + voltage to see it is at the values
specified.
6. Make leakage - current measurements to
determine that exposed parts are acceptably
insulated from the supply circuit before returning
the product to the customer.
7.
2.5A 125V
2.5A 125V
8.
RISK OF FIREREPLACE FUSE
AS MARKED
WARNING!
HIGH VOLTAGE
CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY
WITH SAME TYPE 2.5
AMPERES 125V FUSE.
ATTENTION: AFIN
D'ASSURER UNE
PROTECTION PERMANENTE
CONTRE LES RISQUES
D'INCENDIE, REMPLACER
UNIQUEMENT PAR UN
FUSIBLE DE MEME, TYPE 2.5
AMPERES, 125 VOLTS.
WARNING:
TO REDUCE THE ELECTRIC
SHOCK, BE CAREFUL TO
TOUCH THE PARTS.
2
FinePix S9000/S9500 TROUBLESHOOTING GUIDE
TABLE of CONTENTS
1. Power.........................................................................................................................5
1-1. The camera does not turn on.....................................................................................................5
1-2. The camera does not turn on.....................................................................................................5
1-3. The camera does not turn on.....................................................................................................5
1-4. The camera does not turn on.....................................................................................................5
1-5. The camera does not turn on.....................................................................................................6
1-6. The camera does not turn on.....................................................................................................6
1-7. The camera does not turn on.....................................................................................................6
1-8. The camera does not turn on.....................................................................................................6
1-9. The camera does not turn on.....................................................................................................7
1-10. The camera does not turn on.....................................................................................................7
1-11. The camera does not turn on.....................................................................................................7
1-12. The camera does not turn on.....................................................................................................7
1-13. The camera does not turn on.....................................................................................................7
1-14. The camera does not turn off.....................................................................................................8
1-15. The camera turns off 1 second after being turned on................................................................8
2. Lens............................................................................................................................9
2-1. Resolution error..........................................................................................................................9
2-2. Focusing errors, battery cover damaged ...................................................................................9
2-3. The camera emits a loud abnormal noise during start up..........................................................9
3. Image and trace.......................................................................................................10
3-1. Dust specks appear in images.................................................................................................10
3-2. A card error is displayed and the media cannot be loaded......................................................10
3-3. Images are grainy ....................................................................................................................10
4. LCD...........................................................................................................................11
4-1. The live image is dark..............................................................................................................11
4-2. Live image purple.....................................................................................................................11
4-3. Red border down the left edge of the LCD...............................................................................11
4-4. LCD appears pink ....................................................................................................................11
4-5. Dust contamination in the LCD ................................................................................................11
4-6. LCD fault..................................................................................................................................12
4-7. LCD soiled ...............................................................................................................................12
4-8. LCD cracked ............................................................................................................................12
4-9. LCD image disrupted and then freezes during zooming..........................................................12
3
FinePix S9000/S9500 TROUBLESHOOTING GUIDE
5. Operation.................................................................................................................13
5-1. No perceptible clicking sensation in the shutter release button................................................13
5-2. Shutter release position too deep.............................................................................................13
5-3. BACK button does not work .....................................................................................................13
5-4. Mode dial does not work...........................................................................................................13
5-5. The Power switch is stiff...........................................................................................................13
5-6. The Macro button does not work..............................................................................................14
5-7. The Command dial does not work............................................................................................14
6. Flash........................................................................................................................15
6-1. Flash does not fire in Forced Flash mode................................................................................15
6-2. Flash settings screen not displayed .........................................................................................15
7. Exterior....................................................................................................................16
7-1. Battery cover damaged ............................................................................................................16
7-2. Strap mount damaged/misshapen............................................................................................16
7-3. Damage to the bottom left of the camera due the camera being dropped...............................16
7-4. Lens side face cracked.............................................................................................................16
7-5. Mode dial dislodged..................................................................................................................16
7-6. The LCD window comes off immediately .................................................................................17
7-7. Grip peeling off.........................................................................................................................17
7-8. Play in the grip..........................................................................................................................17
7-9. Loose card cover......................................................................................................................17
7-10. LCD window scratched.............................................................................................................17
8. Others......................................................................................................................18
8-1. Large foreign particle inside the AF sensor..............................................................................18
8-2. LABEL PRODUCT affixed crookedly........................................................................................18
8-3. USB terminal dislodged............................................................................................................18
8-4. The AF auxiliary light does not turn off (stays lit)......................................................................18
4
FinePix S9000/S9500 TROUBLESHOOTING GUIDE
1. Power
1-1. The camera does not turn on
Fault details: The camera does not turn on when running on battery power.
Analysis results: Wire breakage in F602 on the DCST PWB ASSY due to solder ball mixing.
Repair details:
Replaced F602 on the DCST PWB ASSY
1-2. The camera does not turn on
Fault details: The camera does not turn on when running on battery power.
Analysis results: Wire breakage in F602 on the DCST PWB ASSY.
Repair details:
Replaced F602 on the DCST PWB ASSY
1-3. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: The camera does not turn on because pin 13 (VCC) in CN205 on the MAIN PWB is bent
and short-circuits with pin 14 (A06).
Caused by incorrect CF insertion by the user.
Repair details:
Replaced CN205 on the MAIN PWB ASSY
1-4. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: DCST (IC600) part defect.
Repair details:
Replace the DCST PWB ASSY
5
FinePix S9000/S9500 TROUBLESHOOTING GUIDE
1-5. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: C631 on the DCST PWB burned out.
Repair details:
Replace the DCST PWB ASSY
1-6. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: Wire breakage in F602 on the DCST PWB, C603 damaged.
Repair details:
Replace the DCST PWB ASSY
1-7. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: Wire breakage in F602 on the DCST PWB, C628 burned out.
Repair details:
Replace the DCST PWB ASSY
1-8. The camera does not turn on
Fault details: The camera does not turn on.
Analysis results: Wire breakage in F602 on the DCST PWB, C611 burned out.
Repair details:
Replace the DCST PWB ASSY
6
Loading...