FUJIFILM FinePix E500, FinePix E510 SERVICE MANUAL

DIGITAL CAMERA

FinePix

E500/E510

TROUBLESHOOTING GUIDE

US/CA/EU/EG/GE/AS-Model

<E500>
There were no fault examples.

z THE COMPONENTS IDENTIFIED BY THE MARK “

DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR SAFETY.
PLEASE REPLACE ONLY BY THE COMPONENTS SPECIFIED ON THE SCHEMATIC
DIAGRAM AND IN THE PARTS LIST.

z IF YOU USE PARTS NOT SPECIFIED, IT MAY RESULT IN A FIRE AND AN

ELECTRICAL SHOCK.

WARNING

” ON THE SCHEMATIC

FUJI PHOTO FILM CO., LTD.

Ref.No.: ZM00569-400

Printed in Japan 2005. 06

FinePix E500/E510 TROUBLESHOOTING GUIDE

SAFETY CHECK-OUT

After correcting the original problem, perform the following

safety check before return the product to the customer.

1. Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire
board surface for solder splasher and bridges.

2. Check the interboard wiring to ensure that no
wires are “pinched” or contact high-wattage
resistors.

3. Look for unauthorized replacement parts,
particularly transistors, that were installed during
a previous repair. Point them out to the customer
and recommend their replacement.

4. Look for parts which, though functioning, show
obvious signs of deterioration. Point them out to
the customer and recommend their replacement.

5. Check the B + voltage to see it is at the values
specified.

6. Make leakage - current measurements to
determine that exposed parts are acceptably
insulated from the supply circuit before returning
the product to the customer.

7.

2.5A 125V

2.5A 125V

8.

RISK OF FIRE­REPLACE FUSE
AS MARKED

WARNING!

HIGH VOLTAGE

CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY
WITH SAME TYPE 2.5
AMPERES 125V FUSE.

ATTENTION: AFIN
D'ASSURER UNE
PROTECTION PERMANENTE
CONTRE LES RISQUES
D'INCENDIE, REMPLACER
UNIQUEMENT PAR UN
FUSIBLE DE MEME, TYPE 2.5
AMPERES, 125 VOLTS.

WARNING:

TO REDUCE THE ELECTRIC
SHOCK, BE CAREFUL TO
TOUCH THE PARTS.

2