FUJIFILM FinePix A350 TROUBLESHOOTING GUIDE
DIGITAL CAMERA
FinePix A350
TROUBLESHOOTING GUIDE
US/CA/EU/EG/GE/AS/CH/JP-Model
z THE COMPONENTS IDENTIFIED WITH THE MARK “
DIAGRAM AND IN THE PARTS LIST ARE CRITICAL FOR SAFETY.
PLEASE REPLACE ONLY WITH THE COMPONENTS SPECIFIED ON THE SCHEMATIC
DIAGRAM AND IN THE PARTS LIST.
WARNING
” ON THE SCHEMATIC
z IF YOU USE PARTS NOT SPECIFIED, IT MAY RESULT IN A FIRE AND AN
ELECTRICAL SHOCK.
Ref.No.: ZM00584-400
FUJI PHOTO FILM CO., LTD.
Printed in Japan 2005. 08
FinePix A350 TROUBLESHOOTING GUIDE
SAFETY CHECK-OUT
After correcting the original problem, perform the following
safety check before return the product to the customer.
1. Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire
board surface for solder splasher and bridges.
2. Check the interboard wiring to ensure that no
wires are “pinched” or contact high-wattage
resistors.
3. Look for unauthorized replacement parts,
particularly transistors, that were installed during
a previous repair. Point them out to the customer
and recommend their replacement.
4. Look for parts which, though functioning, show
obvious signs of deterioration. Point them out to
the customer and recommend their replacement.
5. Check the B + voltage to see it is at the values
specified.
6. Make leakage - current measurements to
determine that exposed parts are acceptably
insulated from the supply circuit before returning
the product to the customer.
7.
2.5A 125V
2.5A 125V
8.
RISK OF FIREREPLACE FUSE
AS MARKED
WARNING!
HIGH VOLTAGE
CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY
WITH SAME TYPE 2.5
AMPERES 125V FUSE.
ATTENTION: AFIN
D'ASSURER UNE
PROTECTION PERMANENTE
CONTRE LES RISQUES
D'INCENDIE, REMPLACER
UNIQUEMENT PAR UN
FUSIBLE DE MEME, TYPE 2.5
AMPERES, 125 VOLTS.
WARNING:
TO REDUCE THE ELECTRIC
SHOCK, BE CAREFUL TO
TOUCH THE PARTS.
2
FinePix A350 TROUBLESHOOTING GUIDE
TABLE of CONTENTS
1. Power.........................................................................................................................4
1-1. The camera does not turn on.....................................................................................................4
2. Lens............................................................................................................................5
2-1. Lens operation fault....................................................................................................................5
2-2. Zoom error .................................................................................................................................5
2-3. Images will not focus..................................................................................................................5
2-4. Lens barrier does not close........................................................................................................5
3. Image and trace.........................................................................................................6
3-1. Noise (distortion) appears in recorded images ..........................................................................6
4. LCD.............................................................................................................................6
4-1. LCD screen display fault............................................................................................................6
4-2. LCD monitor cracked. ................................................................................................................6
5. Other ..........................................................................................................................7
5-1. Media cannot be loaded.............................................................................................................7
3
Loading...