FRTEK 33BT, 37BT User Manual

INOVA DAS Operating Manual

INOVA DAS

Operating Manual

Document Reference

Company: Fiber Radio Technologies

Version: Ver 1.2

Document Status: Release 1

Issue Date: 2018. 10.

Department: R&D Group 2

Author Manager:

Jun Hyun, Lee

INOVA DAS Operating Manual

Please read this service manual before installation and operation. Use the system only in accordance with contents of this manual.



The specification and information regarding the products in this manual are subject to change due to updates to system functionality or system revision changes without notice. For the latest revision of this manual or for technical inquiries, please contact below :

Company Address : 181 Metro Drive, Suite 580, San Jose, CA 95110 Homepage : http://www.frtek.com

Contact for technical inquires or troubleshooting. Telephone : 330-622-2911 or 510-390-1939

▪

The copyright of this manual is from FRTek Co., Ltd.

This manual may not be reproduced, distributed, modified on any form without the consent of FRTek Co., Ltd

Unauthorized disclosure, distribution, copying or use of the information contained in this document in whole or in part without authority is strictly prohibited.

▪

Trademark

The trademarks mentioned in this manual are registered trademarks of the respective company.

INOVA DAS Operating Manual

Version

Issue Date

Details of Revision

Author

Authorizing

Manager

V 1.0

18. 09. 12.

Original

Jun Hyun, Lee

V 1.1

18. 10. 17.

Revision

Jun Hyun, Lee

V 1.2

18. 10. 22.

Revision

Jun Hyun, Lee

Revision History

This manual is produced by R&D Group 2 Printed in FRTek.

INOVA DAS Operating Manual

Chapter 1

Safety & Certification Notice

1.1

FCC/IC Warning Statements

INOVA DAS Operating Manual

Safety & Certification Notice

1.1

FCC/IC Warning Statements

1.1.1

FCC Part 15.105 statement

This equipment has been tested and found to comply with the limits for a Class A digital device.

These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

1.1.2

FCC Part 15.21 statement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment

1.1.3

Health and Safety Warnings

This system can be operated by approved operator only and operator should observe the warning sentence of operating manual.

The operator who can install, operate or handle related system service should acquaint themselves this manual.

Control and configuration of this system should be set up according to purpose of use (Refer to the

manufacturer’s product information), it has to be satisfied prescribed request items.

Operator should turn off the main power switch before installing system, maintenance and related works.

If this product is disassembled intentionally, it can bring electric shock, breakdown, malfunction and static with losing life and property. Do not disassemble, repair and modify product.

This system cover should be (door) securely fastened in open position, e.g. by tying it up, at outdoor

INOVA DAS Operating Manual

Warning

work in order to prevent door from slamming due to wind causing bodily harm or damage.

Due to power dissipation, the remote unit may reach a very high temperature. Do not operate this equipment on or close to flammable materials. Use caution when servicing the unit.

Use this equipment only for the purpose specified by the manufacturer. Do not carry out any modifications or fit any spare parts, which are not sold or recommended by the manufacturer. This could cause fires, electric shock or other injuries.

Read and obey all the warning labels attached to the unit. Make sure that all warning labels are kept in a legible condition.

It is the responsibility of the network provider to implement prevention measures to avoid health hazards associated with radiation from the antenna(s) connected to the unit.

Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives.

Although the remote unit is internally protected against overvoltage, it is strongly recommended to ground (earth) the antenna cables close to the repeater’s antenna connectors for protection against atmospheric discharge.

Obey all general and regional installation and safety regulations relating to work on high voltage installations, as well as regulations covering correct use of tools and personal protective equipment.

Use of unauthorized antennas, cables, and /or coupling devices not conforming with ERP/EIRP and

/or indoor‐only restrictions is prohibited.

Laser radiation! Do not stare into the beam; do not view it directly or with optical instruments.

INOVA DAS Operating Manual

maintained between the radiator (antenna) and all persons at all times. This device must not be co-

located or operating in conjunction with any other antenna or transmitter.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce

potential radio interference to other users, the antenna type and its gain should be so chosen that

the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful

communication.

Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut

fonctionneravec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur

par

Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention

desautres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance

isotroperayonnée quivalente (p.i.r.e.) ne dépassepas l’intensité nécessaire à l’établissement d’une

communication satisfaisante.

Please be informed that the temperature of the surface is too high.

Please be careful. The label is attached to the front of the equipment

and the PSU (Power Supply Unit).

•

[FCC] RF Exposure Statement

The antenna(s) must be installed such that a minimum separation distance of at least 20cm is

•

[IC] RSS-GEN, Sec. 7.1.2 – (transmitters)

INOVA DAS Operating Manual

This equipment complies with RF radiation exposure limits set forth for an uncontrolled

between the radiator and your body. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter. RF exposure will be addressed at time of installation and the use of higher gain antennas require larger separation distances.

L’antenne (ou les antennes) doit être installée de façon à maintenir à tout instant une distance

Cet appareil ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou émetteur.

•

RF Radiation Exposure

environment. This equipment should be installed and operated with a minimum distance of 20 cm

minimum de au moins 20cm entre la source de radiation (l’antenne) et toute personne physique.

INOVA DAS Operating Manual

Chapter 2

System Overview

2.1

2.2

System Overview System Network Configuration

+ 19 hidden pages

FRTEK 33BT, 37BT User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual