FRIGIDAIRE FH36DD50MS User Manual
Drop-In Cooktop
Downdraft Vent
FPEC3085K S
FH36DD50M S
Signature Features
Infinite-Speed
Blower Control
The ultraquiet blower allows you to
select the precise airflow needed.
Push-Button
Auto Raise / Lower
When activated, the downdraft rises
10" to capture even the most stubborn
cooking odors. Can be vented through
wall or floor.
30" Electric
36" In-Cabinet
Features
Nominal Width 36"
Installation Type Downdraft
Style In-Cabinet
Controls Push Button
Air Discharge Right and Left
Air Delivery (CFM) 600
Intake Area 128 Sq. In.
Blower Type Centrifugal
Sound Level (dBA) 59.7
Fan Speeds Infinite-Speed
Dishwasher-Safe
Stainless Steel Filters
Exhaust Duct External
Duct Required
Specifications
Product Dimensions –
Height (Including 10" Rise) 34-5/16"
Width 36"
Depth 11-7/16"
Voltage Rating 120V / 60 Hz / 15A
Connected Load (kW Rating)
@ 120 Volts‡
Amps @ 120 Volts 3.4
Motor Power Cord Location Right Middle Side
Shipping Weight (Approx.) 68 Lbs.
Sones Rating 9.0
‡ For use on adequately wired 120V, dedicated circuit having
2-wire service with a separate ground wire. Appliance must
be grounded for safe operation.
NOTE: Always consult local and national electric codes. Check
local building codes for installation requirements, as they
may vary per locale. Refer to Product Installation Guide for
detailed installation instructions on the web at frigidaire.com.
Specifications subject to change.
Available in:
Stainless
(S)
2
3-1/4" x 10"
or 6" Round
.41
Dishwasher-Safe Filters
Filters remove even the most persistent
cooking odors and clean up easily by
cycling through your dishwasher.
frigidaire.com
36" Downdraft Vent - (FH36DD50MS)
Frigidaire Baseline
Downdraft Vent
FH36DD50M S 36" In-Cabinet
Downdraft Vent Specifications
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.41 kW (For use on
adequately wired 120V, dedicated circuit having 2-wire service with a
separate ground wire. Appliance must be grounded for safe operation.)
•
Amps @ 120 Volts = 3.4 Amps
•
Do not use same circuit as cooktop.
•
Always consult local and national electric codes. Check local building
codes for installation requirements, as they may vary per locale.
•
Locate grounded electrical outlet for 28"- long power cord within
reachable distance. When installing vent in 36"- wide cabinet, outlet
cannot be located on back wall of cabinet, but can be wall-mounted
with access hole in cabinet.
•
Downdraft Vent designed for installation with cooktop in island,
peninsula or conventional installation. (Cutout template provided,
packed with vent.)
•
To ensure proper installation with cooktop, refer to model-specific
cooktop installation guide on web for dimensions, countertop
cutout dimensions and cabinet requirements; oversized cabinets
recommended for ease of installation. Due to varying cooktop depths,
tight fit is possible between cooktop and vent, depending on overall
depth of countertop.
•
Pre-formed countertops with raised lip and /or backsplash may not
allow enough flat area for proper installation. Minimum 2-5/16" of flat
countertop required behind cooktop and 2-1/16" necessary between
•
Vent exhaust air outside only.
•
Exhaust Duct Required – Galvanized or aluminum duct in 6" round
or 3-1/4" x 10" rectangular, or combination of both. PVC should
be used if installing under concrete slab.
•
Three blower discharge direction options available; rotate blower
motor for left, right or down discharge.
•
Consider ductwork location before cutting hole in cabinet. Blower
motor mounted on slide plate, enabling 3-1/2" left or right adjustment
to avoid duct interference with joists or other obstructions.
•
For maximum efficiency, use shortest and straightest duct run
possible. System operates most efficiently with up to 60 equivalent
feet of duct; Downdraft Vent operates properly with ductwork
up to 100 equivalent feet. (Refer to Calculating Duct Length Table
in Product Installation Guide.)
•
Do not use flexible duct. Round duct instead of rectangular duct
recommended, especially when elbows are required.
•
Thermal breaks such as short section of nonmetallic duct, should
be used in areas of extreme cold. Cold weather installations should
have additional backdraft damper installed.
•
High level of airflow may affect gas flame on some gas cooktop
models.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
back edge of cooktop and inside of cabinet back.
•
To ensure adequate clearance for air vent when raised /lowered, 1/8"
gap needed between back edge of cooktop and front of downdraft
top trim.
•
USA
10200 David Taylor Drive
•
CANADA
FH36DD50M 07/12 © 2012 Electrolux Home Products, Inc.
5855 Terry Fox Way
•
Charlotte, NC 28262
•
Mississauga, ON L5V 3E4
•
1-800-FRIGIDAIRE
•
1-800-265-8352
•
frigidaire.com
•
frigidaire.ca
Accessories information available
on the web at frigidaire.com
Specifications
subject to change.
Loading...