Franke Foodservice HCMF-30 18005056 Parts List

TECHNICIAN’S QUICK REFERENCE GUIDE -

HIGH-CAPACITY MEAT FREEZER (HCMF) – 30”

DOCUMENT PART NUMBER 19010024 REV A, 01-26-17

PART #’S:

18005056

(For other units, verify compatibility of parts with Technical Support before ordering)

SERVICE PARTS

ITEM # PART NUMBER DESCRIPTION QTY

1 19004310 Condensing Unit, 0.5 HP, MT, R-404A 1

2 19005289 Compressor Kit, NF7CLX, 115V/60Hz 1

3 19005291 Relay, Start, for NF7CLX, 115V/60Hz 1

4 19005292 Capacitor, Start, for NF7CLX, 115V/60Hz 1

5 70008094 Overload 1

6 19008907 Refrigeration Receiver 1

7 3126151 Switch, Carling LTA201TRB/125N 1

8 19004313 Switch, High Limit 1

9 19008906 Filter Drier, 1/4” 1

10 19008902 Fan Motor, Condenser, 9W 1

11 19000454 Fan Motor, Evaporator 2

12 19001190 Valve, Thermostatic Expansion, #1 1

13 19004308 Heating Element, Defrost 1

14 19004309 Gasket, Door 1

15 19004449 Gasket, Lid 1

16 19000817 Caster, Swivel, with Brake, Plate 4

17 19000282 Cord Set, 1/43 SJTOW, 105C Stranded 1

18 19004376 Wiring Harness 1

19 18005958 Controller, Eliwell 1

20 19004832 Temperature Sensor, Coil, Eliwell 1

21 19004769 Temperature Sensor, Air, Eliwell 1

NOTICE!

SERVICE PERFORMED BY NON-AUTHORIZED SERVICE PROVIDERS OR USE OF NON-OEM PARTS MAY VOID EQUIPMENT WARRANTY.

Franke Foodservice Solutions, Inc. 800 Aviation Parkway Smyrna, TN 37167, USA Tel + 1.800.5.FRANKE, opt. 2

(1.800.537.2653, opt. 2)

Outside the US:

1.615.462.3231, opt. 2

www.frankefs.com

ELIWELL CONTROL SETTINGS & OPERATING CHARACTERISTICS

(For Trouble Shooting Reference) Bottled Beverage Refrigerator

Temperature Controller Options For More Information

Temperature Range Adjustable

Coldest Set Point -30°F

Normal Cut Out (Set Point) -4°F

Normal Cut In -2°F

Warmest Set Point 30°F

Compressor Protection Fixed

Minimum Time From Start to Start 2 minutes

Fail Safe Mode (if sensor fails) Fixed

Faulty Probe On Time 4 minutes

Faulty Probe Oﬀ Time 2 minutes

Defrost Settings Fixed

Termination Temp 60°F

Maximum Time Allowed 60 minutes

Drip Time (heat oﬀ) 1 minute

Defrost Based On Compressor On Time Fixed

Time Between Defrosts 3 hours

Fan Settings Fixed

During Defrost Oﬀ

Start Delay After Defrost 4 minutes

Start Delay N/A

Display Features Adjustments See Service Manual for Instructions

Can select degrees F or C? No

Can adjust temperature from display? Yes

Can Initiate Defrost from display? Yes

Display During Defrost Cycle:

dEF

Refrigerant Type Amount, Ounces

R-404A HCMF-30 19 oz

Normal Operating Pressures Normal Operating Amps

High Side (85 air to condenser) 235 PSIG HCMF-30 8 - 9 Amps, 4.8 Amp Defrost

Low Side (-5 air into coil) 13 PSIG HCMF-18 5 - 6 Amps, 3.8 Amp Defrost

High Pressure Safety Rated Operating Amps

Cut Out Setting 460 PSIG HCMF-30 10 Amps

Diﬀerential 30 PSIG HCMF-18 7 Amps

Defrost High Limit Safety Operating Voltage

Cut Out Setting 70°F HCMF-30 120V

Diﬀerential 15°F HCMF-18 120V

See Service Manual for Adjusting Temperature

Display Error Codes: E1 = Air Sensor Error, E2 = Defrost Sensor Error, AH1 = High Alarm, AL1 = Low Alarm, Ad2 = Defrost Timeout Alarm

Fan cycles on and oﬀ after compressor shuts oﬀ. Fans on when compressor is on.

dEF Message shown for a maximum 30 minute after defrost

HCMF-18 11 oz

© 2016 Franke Foodservice Solutions, Inc. This media is the conﬁdential and proprietary property of Franke Foodservice Solutions, Inc. and shall not be reproduced in any form of media without the express written permission of Franke. Due to continuous product development, Franke reserves the right to make changes in design and speciﬁcations without prior notice. Trademarks used are the property of their respective owners. Printed in the USA under license by Franke Technology and Trademark Ltd., Switzerland.

For Support, Please Call: Tel + 1.800.5.FRANKE, opt. 2

(1.800.537.2653, opt. 2)

Outside the US:

1.615.462.3231, opt. 2