Page 1
User Manual
CSR8510
Bluetooth 4.0 USB Dongle
FortiExplorer
Version: 0.1
Page 1
Page 2
Version
Date
Revision Description
Editor
0.1
Sep 19th, 2018
Preliminary
Tiffany
▌Revision History
Page 2
Page 3
▌PRODUCT DESCRIPTION
CSR8510 A10 is a product from CSR’S connectivity Centre. It is a single-chip radio and baseband IC
for Bluetooth 4.0 GHz(4.0 with 2.4GHz) systems including EDT(EDR) to 3 Mbps. Dedicated singal and
baseband processing is included for full Bluetooth operation.
▌PRODUCT FEATURES:
Fully qualified Bluetooth v4.0 specification system
Support for Bluetooth v3.0 (For Bluetooth v3.0 + HS operation a separate 802.11 IC is used in
conjunction with CSR8510 WLCSP) only available with CSR8510 A10
Dual-mode Bluetooth / Bluetooth lower energy
Full-Speed USB 2.0 interface
Green(RoHS compliant and no antimony or halogendated flame retardants)
Proximity, Generic Attribute Profile
Page 3
Page 4
HARDWARE SPECIFICATION
Standard
Bluetooth 4.0
Main chip
CSR8510 A10
Memory
EEPROM 32K CSR recommends a minimum 64Kb EEPROM when using
HID functionality and 32Kb EEPROM for just HCI functionality.
Profiles
Bluetooth low energy
Dual-mode Bluetooth
Frequency Band
2.402G – 2.480G
Sensitivity
- 86dBm@0.1% BER
RF TX Power
+6dBm (Class П)
Power
Supply voltage : 5V DC (MAX5.75V)
Working Current
Depends on profiles, 22mA typical
Standby Current
(connected)
0.4 uA
Operating Temperture
0 oC to + 45oC, (32 ~ 122oF)
Storage Temperature
-20 oC to 70oC, (-40 ~ 158oF)
Humidity
10% ～90% Non_Condensing
Environmental
RoHS Compliant
▌SPECIFICAION
Page 4
Page 5
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the
user body or set the device to lower output power if such function is available.
Page 5
Page 6
Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas
produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement indésirable.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user body
or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les Etats-Unis
et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que possible du corps
de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle
fonction est disponible.
Page 6
Loading...