Page 1
INSTALLATION INSTRUCTIONS FOR PART 95-5025
APPLICATIONS
FORD Mustang
1987-1993
95-5025
KIT FEATURES
• Double DIN Head Unit Provision
• ISO Stacked Head Unit Provision
KIT COMPONENTS
A) Double DIN Brackets • B) Double DIN Trim plate • C) (4) # 8 X 1” Phillips Screws
A
WIRING ANDANTENNA CONNECTIONS (Sold Separately)
• 70-1770 - Ford harness - 1985-2004
• Phillips Screwdriver • Socket Wrench • Rotary Cutting Tool
• Radio Removal Tools (Part # 86-5618)
1-800-221-0932
© COPYRIGHT 2009 METRA ELECTRONICS CORPORATION
B
TOOLS REQUIRED:
www.metraonline.com
C
Page 2
95-5025
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills
by enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call 800-354-6782 for more information
and take steps toward a better tomorrow.
TABLE OF CONTENTS
Dash Disassembly
- Ford Mustang 1987-1993 .........................................1
Kit Assembly
- Double DIN Head Unit Provision................ ....................2
- ISO Stacked Head Unit Provision ...................................2
*Note:
Refer also to the instructions included with the aftermarket radio.
Page 3
95-5025 DASH DISASSEMBLY
ALSO REMOVE (2) THREADED STUDS FROM UNDER BRACKET
7/16” (2)
HEX BOLTS
RADIO SUB-DASH BRACKET
FORD MUSTANG 1987-1993
A
Disconnect the negative battery
1
terminal to prevent an accidental
short circuit.
Using Metra's 86-5618, pull the
2
factory head unit from the dash and
disconnect the wiring.
3
Remove two 7/16” hex bolts from inside the dash cavity and remove the radio
sub-dash bracket. (See recommended tool list on front cover)
The threaded studs from under this bracket will also need to be removed for
Note:
the aftermarket Double DIN radio to clear.
Continue to kit assembly.
(Figure A)
(Figure B)
B
1
Page 4
95-5025 KIT ASSEMBLY
DOUBLE DIN HEAD UNIT PROVISION/
ISO STACKED HEAD UNIT PROVISION
Locate the factory wiring harness in
1
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
Attach the Double DIN brackets to the
2
Double DIN radio or stacked ISO head
units using the screws supplied with
the radio.
(Figure A)
A
3
Mount the head unit/ kit assembly to
the dash using the four supplied # 8 x
1” Phillips screws.
(Figure B)
B
1-800-221-0932
REV. 08-19-09 © COPYRIGHT 2009 METRA ELECTRONICS CORPORATION INST95-5025
www.metraonline.com
Loading...