Fluid Components International MT86, MT86HT User Manual

APPENDIX D - CE CONFORMANCE FLUID COMPONENTS INTL

Appendix D. CE Conformance

APPROVED CE MARKING CONFIGURATIONS

Approved Options

1) All process temperature ranges

2) All metallic sensor elements

3) All process connections and flanges

4) All insertion U-lengths

5) Aluminum and 300 series stainless steel NEMA 4X local and remote enclosures

6) All specified application combinations

7) All cable jackets and lengths

8) 115/230 VAC input power

Approved Part Numbers

MT86

and

MT86HT

All other configurations must be approved for CE marking conformity by FCI's Engineering Department.

1-20

21 22-40

B C
D E

All options conform to CE marking
requirements.

X Y

X or Y options only conform to CE marking

CONDITIONALLY APPROVED CE MARKING CONFIGURATIONS

24 VDC Factory Selectable Option

The models included in this family may be factory selected for input power of 24 VDC. Since the manufacturer
does not supply the power source or transformer for these connections, the responsibility for the conditioning of
these sources and associated compliance to the EMC Directive shall be the responsibility of the User.

Panel Mounted Control Circuit Options

Input power of 24 Vdc may be optionally selected. Sense the manufacturer does not supply the power source for
these connections, the responsibility for the conditioning of these sources and associated compliance to the EMC
Directive shall be the responsibility of the user.

Doc. No. 003162 Rev. F D - 1 Models MT86, MT86HT

FLUID COMPONENTS INTL APPENDIX D - CE CONFORMANCE

INSTALLATION CONFORMITY CRITERIA

Grounding

All enclosures must be grounded to earth ground through a path of less than 1 ohm.

Interconnecting Cables

All interconnecting cables between the instrument's local enclosure, remote enclosure, power source and mounting
device shall be enclosed in metal conduit. AC power input cabling shall be enclosed separately in conduit before
entrance into the instrument and is not to be combined with switch or monitor output cabling.

LOCATION OF CE MARK DOCUMENTATION

European Location

The technical documentation file part A resides at Fluid Components Intl, European Service Center, Beatrix
De Rijkweg 8, 5657 Eg Einhoven, Netherlands, Phone: [phone] FAX: [phone].

Manufacturer Location

The technical documentation file part B resides at the Configuration Management department of Fluid Components
Intl. 1755 La Costa Meadows Dr., San Marcos, CA 92069 USA, Phone: [phone] FAX: [phone].

Models MT86, MT86HT D - 2 Doc. No. 003162 Rev. F