FLIR N233VE User Manual
Quick Connection Guide
N233VE
3MP IP Vandal Dome Camera
PACKAGE CONTENTS:
1 x IP Vandal Dome Camera
3 x Mounting Screws
1 x RJ45 Waterproof Cap
Quick Start Guides
1 x Allen Key
3 x Drywall Anchors
1 x Mounting Template
1 x CD
1
A
B
C
D
E
Installing the Camera
Use the included Allen key to loosen the screws on the
dome cover. Remove the dome cover.
Use the included mounting template to mark holes for
the mounting screws and camera cable.
Drill holes for the mounting screws and camera cable.
NOTE: Use the included drywall anchors if installing into
drywall.
Connect cables as shown in the section “Connecting the
Camera”.
Attach the camera base to the mounting surface using
the included mounting screws (3x).
Drywall anchors (3x)
Mounting screws (3x)
2
F
G
H
Installing the Camera (continued)
Set the position and angle of the camera.
1.
Rotate the camera around the base (rotates 360°
before it is stopped).
2.
Use a Phillips screwdriver to loosen the adjustment
screws on both sides of the camera module. Tilt the
camera module. Tighten both screws when finished.
3.
Adjust the position of the camera lens by twisting the
camera lens housing.
1 2 3
Replace the dome cover. Use the included Allen key to
tighten the screws (3x).
ATTENTION: Make sure IR LEDs are not blocked
by the dome cover to prevent IR reflection.
Remove the vinyl film from the dome cover.
3
1.
Power Input: If not using PoE, connect the camera to a
12V DC power source (370mA or higher required).
2.
Alarm I/O (Optional): Connect alarm/sensor devices (not
included).
3.
Ethernet Port: Connect the camera to an NVR or a router
or switch on your network using Cat5e or better Ethernet
cable (not included). PoE Class 3 supported.
NOTE: Install the included RJ45 waterproof cap if needed.
4.
Audio I/O (Optional): See the Instruction Manual for
details.
Connecting the Camera
1
2
3
4
Latest software and manuals available on
www.flir.com/security/support
For support, visit
www.flir.com/security/support
Information in this document is subject to change
without notice. As our products are subject to continuous
improvement, FLIR Systems, Inc. and our subsidiaries reserve
the right to modify product design, specifications and
prices, without notice and without incurring any obligation.
E&OE © 2015 FLIR Systems, Inc. All rights reserved.
Weights & Dimensions
Weight
0.8lb /
0.4kg
3.2” /
81mm
4.3” /
110mm
Remove the dome cover.
A
Slide the metal cover down to open it.
B
Insert the microSD card (not included)
C
into the slot.
Close the cover and slide it up to lock
D
the microSD card in place.
Replace the dome cover. Tighten the dome cover screws (3x).
E
Reset button microSD slot
Resetting the Camera
Remove the dome cover. Make sure the camera is powered on.
A
Press and hold the reset button on the camera base for 5 seconds to
B
reset the camera to default settings.
Replace the dome cover. Tighten the dome cover screws (3x).
C
Safety PrecautionsInserting the microSD Card
• Use an appropriate low voltage power cable to prevent fire or
electrical shock.
• Make sure to install the camera in an area that can support the
camera weight.
• There are no user serviceable parts inside the camera. Please do not
disassemble the camera.
• Do not clean the lens cover with an abrasive cleaning material. Please
use a lint free micro-fiber cloth to clean the lens cover.
• Camera is rated for outdoor use (IP66), but is not intended for
submersion in water.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
N233VE_QCG_EN_R1
Loading...