Flir N133BD, N133BD-2 User Manual
Quick Connection Guide
N133BD
2MP HD IP Bullet Camera
PACKAGE CONTENTS:
1 x IP Bullet Camera
4 x Mounting Screws
Quick Start Guides
1 x Phillips Allen Key
4 x Drywall Anchors
1 x CD
1
A
B
C
D
Installing the Camera
Use the included mounting template to mark holes for the
mounting screws.
Drill holes for the mounting screws.
NOTE: Use the included drywall anchors if installing on a
drywall surface.
Connect cables as shown in the section “Connecting the
Camera”.
Mount the camera to the surface using the included
mounting screws (4x).
Drywall anchors (4x)
Mounting screws (4x)
Mounting template
2
A
B
C
Adjusting the Camera
Use the included Phillips Allen key to loosen the
adjustment screw on the camera mounting bracket.
Adjustment screw
Move the camera to the desired position. Tighten the
adjustment screw when finished.
Remove the vinyl film from the camera lens once
installation is complete.
3
1. Ethernet Port: Connect the camera to an NVR or a router or
switch on your network using Cat5e or better Ethernet cable
(not included). PoE Class 3 supported.
2. Power Input: If not using PoE, connect the camera to a 12V
DC power source (300mA or higher required).
Connecting the Camera
1
2
Latest software and manuals available on
www.flirsecurity.com/pro
For support, visit
www.flirsecurity.com/pro
Information in this document is subject to change
without notice. As our products are subject to continuous
improvement, FLIR Systems, Inc. and our subsidiaries reserve
the right to modify product design, specifications and
prices, without notice and without incurring any obligation.
E&OE © 2014 FLIR Systems, Inc. All rights reserved.
3.1” / 78mm
Weights & Dimensions
Weight
1.4lbs / 0.6kg
6.8” /
173mm
2.8” /
72mm
Safety Precautions
• Use an appropriate low voltage power cable to prevent fire or electrical
shock.
• Make sure to install the camera in an area that can support the camera
weight.
• There are no user serviceable parts inside the camera. Please do not
disassemble the camera.
• Do not clean the lens cover with an abrasive cleaning material. Please use
a lint free micro-fiber cloth to clean the lens cover.
• Camera is rated for outdoor use (IP66), but is not intended for submersion
in water.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
N133BD_QCG_EN_R1
Loading...