Fishman NASHVILLE INSTALLATION GUIDE
NASHVILLE SERIES PICKUPS
INSTALLATION GUIDE
www.fishman.com
Read Me First!
If you are unfamiliar with these products, please pay
close attention to the dimensional requirements for
installation. Failure to do so can result in permanent
damage to the pickup.
Installation of this product is a straightforward
procedure, but we recommend this job only if you
are an experienced repair technician.
0.050”
0.050”
Preliminary
The Nashville Series fl at-top and two piece archtop
mandolin pickups feature a piezo-ceramic element preinstalled in the bridge. Use your preferred
method for bridge fi tting.
For the fl at-top model (M-400), up to .050” may
be removed from either the top or bottom of the
bridge (Figure 1).
For the archtop model (M-300), up to .180” may be
removed from the base during fi tting (Figure 2).
Special care must be taken not to damage the
pickup wire when tooling the bridge blank.
Installing The Jack
After fi tting the pickup, place the jack in a com-
fortable location (Figure 3) and tighten it with the
enclosed turnbuckle key (Figure 4). Be careful not to
scratch the side of your instrument.
Figure 1. M-400
0.180”
Figure 2. M-300
www.fi shman.com
Figure 4.Figure 3.
514-300-004 Rev A 3-08
Loading...