Page 1
Sit
Ride
Ride
W9740
Walk
Please keep this instruction sheet for future reference, as it contains important information.
For ages 9 – 36 months and up to 44 lbs (20 kg).
Adult supervision is required.
Never use near steps.
Choose areas for riding that are free of obstacles.
Learn to stop safely.
Use with caution as this product requires skill to operate safely to avoid falls, collisions,
and injuries to yourself (the rider) and others.
Requires three “AA” batteries (included) for operation.
Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included).
fisher-price.com
Page 2
Assembled Parts
Puppy
Assembly
CAUTION
This package contains small parts.
For adult assembly only.
Puppy
Frame
2 Rear Wheels
#8 x 1¼" (1,9 cm) Screws – 7
Shown Actual Size
2 Hubs
Handle
1
Frame
• Fit the frame to the puppy.
2
• While holding the puppy in place, carefully turn the
assembly over.
• Insert three screws into the frame and tighten.
Note: Tighten and loosen all screws with a Phillips
screwdriver. Do not over-tighten screws.
2
Page 3
Assembly
.
PRESS
PRESS
Handle
Handle
PRESS
3
• Carefully turn the assembly upright.
• Press the bar under the back of the seat and lift the seat.
4
• Insert two screws into the top of the frame and tighten.• Insert two screws into the top of the frame and tighten
PRESS
5
• Press the bar on the bottom of the seat and lower the seat.
• Insert and "snap" the handle into the sockets in the seat.
6
• Fit a rear wheel onto the peg on one of the back legs.
3
Rear Wheel
Page 4
Assembly
Assembl
y
7
• Fit a hub into the center of the rear wheel.
Hub
Battery Replacement
1,5V x 3
“AA” (LR6)
For best performance, we recommend that you replace the
batteries that came with this toy with three, new “AA” (LR6)
alkaline batteries.
• Locate the battery compartment on the back of the puppy's head.
• Lift the seat to access the battery compartment.
• Loosen the screws in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
• Replace the battery compartment door and tighten the screws.
• If this product begins to operate erratically, you may need to
reset the electronics. Slide the power/volume switch off and
then back on.
• When sounds or lights become faint or stop, it’s time for an
adult to change the batteries.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities.
8
• Insert a screw into the center of the hub and tighten.
• Repeat this procedure to assemble the other rear wheel, hub
and remaining screw.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your toy. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of batteries
safely. Do not dispose of the product in a fire. The batteries
inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
4
Page 5
Rewarding Music & Lights!
Walker
Ride-On
PRESS
PRESS
PRESS
PRESS
Walker
Convert to Walker
• Press the bar under the back of the seat and lift it until it
"snaps" in place as a handle.
• Push the handle to be sure it is secure.
Convert to Rider
• Press the bar on the bottom of the handle and lower it as a seat.
Ride-On
• Slide the power/mode switch to: Learning , Music
or Imagination mode.
Learning - Press the shape buttons to learn shapes and
colors or hear a song. Press the puppy's nose or open
and close puppy's mouth to hear phrases. Listen to songs
when you roll the puppy!
Music - Press the shape buttons to hear fun sounds.
Press puppy's nose, open puppy's mouth or roll the puppy
to hear fun songs!
Imagination - Press the shape buttons, press puppy's nose,
open puppy's mouth or roll the puppy for sounds and phrases!
• Slide the volume switch to low or high volume.
• When you are finished playing with this toy, slide the power/mode
switch OFF .
5
Page 6
Consumer Information
ASSISTANC
FCC Statement (United States Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment. This device complies with
Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
ICES-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
NSUMER
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
E
Care
• Wipe with a clean cloth dampened with a mild soap and water
solution. Do not immerse.
• Periodically inspect this product for wear or damage. Check all
nuts and bolts, and tighten as needed. Replace worn or broken
parts immediately.
NMB-003
• Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux
conditions suivantes : (1) il ne doit pas produire de brouillage
et (2) l’utilisateur du dispositif doit être prêt à accepter tout
brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement du dispositif.
©2012 Mattel. All Rights Reserved.
PRINTED IN MEXICO W9740a-0920
Loading...