Page 1
Fitting Steps
Fitting Guide & Tips
1. Use fingers to gently spread the soft wings
of the Silicone Seal and guide silicone
openings into nostrils.
2. Hold the Mask Frame in position with one
hand and pull the Headgear over the head
with the other.
3. Gently loosen the Headgear straps until a
comfortable seal is achieved, then slightly
tighten and fasten Headgear.
F&P Brevida is a registered trademark of Fisher & Paykel Healthcare .
REF 613108 REV A 2017-09 © 2017 Fisher & Paykel Healthcare Limited
www.fphcare.com
See reverse side for fitting tips
Page 2
Fitting Tips
For more information, look for F&P Brevida
at www.youtube.com/user/fphealthcare
Fitting Guide & Tips
Connect mask to CPAP hose and turn device on.
Check that the Silicone Seal (Cushion) has
inflated with air.
Check that the silicone openings are not
inverted. If they are, gently ‘flick’ them out
with one finger.
Be gentle when spreading the soft side wings;
do not use finger nails.
Check that the silicone openings are not inverted
before they are placed into the nostrils.
Once the silicone openings are placed into the
nostrils, put one hand on the strap labelled
“Brevida” and pull over your head. The upper and
lower strap should be spread open so that the
Headgear sits securely on the head.
If you experience any leaks after fitting your
mask, you may need to lift the Silicone Seal o
your nose and reposition it again so that the two
silicone openings fit securely into your nostrils.
Ensure the Headgear straps are not fastened too
tightly. The Silicone Seal should feel secure in the
nostrils, but not too tight.
Loading...