Page 1
Technical Parameters
ANSI/PLAT
O FL1
Turbo High Med Low Red Signal SOS
Fenix LD15R Flashlight
White Light Red Light
Output
Runtime
Distance
Intensity
Impact
Resistance
500
Lumens
1h
20min*
150
Lumens30Lumens3Lumens4 Lumens
2h
50min
13h
20min
110h 30h / /
4
Lumens
Lumens
85m 46m 23m 6m 5m / /
1,800cd 530cd 135cd 9cd 6cd / /
1m
4
IP68, underwater 2m
Waterproof
Notice: The abovementioned parameters (lab-tested by using Fenix ARB-L16-700 rechargeable Li-ion
battery) may vary between flashlights, batteries and environments.
*The runtime of Turbo is the accumulated time when time-limited downshifting activates and works.
Cree XP-G3 white LED with lifespan of 50,000 hours
EVERLIGHT red LED
Powered by one 16340 rechargeable Li-ion battery or CR123A Lithium battery
5V/1A Micro USB charging
70mm Length x 19mm Body diameter
40 grams (excluding battery)
Battery level indication
Digitally regulated output maintains constant brightness
Two-way body clip and magnetic tail
Reverse polarity protection to protect from improper battery insertion
Low-voltage warning reminds when battery replacement is needed
Made of durable high-strength and oxidation-resistance aluminum
Premium type HAIII hard-anodized anti-abrasive finish
Fitted with high quality optical lens
Page 2
Operating Instruction
ON/OFF
With the light switched off, press and hold the top switch for 0.5 seconds to turn on the light on the
last used output.
With the light turned on, press and hold the top switch for 0.5 seconds to turn off the light.
Output Selection
With the light switched on white light mode, single click the top switch to cycle through
Low→Med→High→Turbo.
With the light switched on red light mode, single click the top switch to cycle through Red→Signal
Light→SOS.
Mode Switching
In white light mode, press and hold the top switch for 1.2 seconds to enter red light mode.
In red light mode, press and hold the top switch for 1.2 seconds to enter white light mode.
Battery level Indication
With the light switched off, single click the top switch. The battery level indicator will display the
battery status for 3 seconds.
Green constant on: saturated, 100% - 85%
Green flashes: sufficient, 85% - 50%
Red constant on: poor, 50% - 25%
Red flashes: critical, 25% - 1%
Note: There is no indication when CR123A battery is used.
Charging
1. Turn off the light. Plug the USB side of the charging cable into any USB power supply. Uncover the
anti-dust cap of the light, and plug the Micro USB side of the charging cable into the charging port of
the light.
2. The battery level indicator displays red while charging and turns to solid green when charging is
complete. The normal charging time of the included Fenix ARB-L17-700 is about 1.5 hours.
3. Once charging is completed, be sure to remove the charging cable and replace the anti-dust cap to
protect against dust and foreign objects.
4. Recharge a stored light every four months to maintain optimum performance of the battery.
5. Only Low output can be used when the light is being charged, but charging time will be prolonged.
Battery Specifications
Type
Dimensio
Fenix ARB-L16-700 16340 3.7V Recommended √√
Non-rechargeable
Battery (Lithium)
CR123A 3V Usable √
Rechargeable Battery
(Li-ion)
Warning: For emergency situation, non-rechargeable CR123A battery can be used, but charging is
prohibited. Rechargeable Li-ion battery with no protection board is forbidden.
**16340 rechargeable Li-ion batteries are powerful cells designed for commercial applications and
must be treated with caution and handled with care. Quality batteries with circuit protection will
reduce the potential for combustion or explosion but cell damage or short circuiting are potential risks
the user assumes.
Battery Replacement
Unscrew the tail cap to insert the battery with the anode side (+) towards the light head, then screw
Nominal
n
Voltage
Usability
16340 3.6V/3.7V Cautious**
！
Page 3
the tail cap back on.
Time-limited Output Downshifting
The light will accumulate a lot of heat when working at Turbo output level. To prevent high surface
temperature the light is programmed to downshift to 200 Lumens after working for 5 minutes.
Intelligent Memory Circuit
The light memorizes the last selected brightness level on white light mode. When turned on again the
previously used brightness level will be recalled.
Low-voltage Warning
When the voltage level drops below a preset level, the flashlight is programmed to step down to a
lower brightness level until Low output is reached. When this happens in Low output level, the battery
level indicator will display red and the flashlight blinks every three seconds to remind you to replace
the battery. To ensure normal use, the flashlight will work until the battery runs out.
Note: This only work with the rechargeable 16340 Li-ion battery.
Usage and Maintenance
Disassembling the sealed head can cause damage to the light and will void the warranty.
Fenix recommends using an excellent quality battery.
If the light will not be used for an extended period, remove the battery, or the light could be
damaged by electrolyte leakage or battery explosion.
Unscrew the tail cap half a turn or take out the battery to prevent accidental activation during
storage or transportation.
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with
an approved spare．
Periodic cleaning of the battery contacts improves the lamp's performance as dirty contacts may
cause the lamp to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: The battery needs replacing.
Solution: Replace battery (Ensure battery is inserted according to the manufacturer’s
specifications).
B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don't work, please contact your authorized distributor.
Warning
This flashlight is a high-intensity lighting device capable of causing eye damage. Avoid shining the
flashlight directly into anyone’s eyes.
Included in the package
LD15R, ARB-L16-700 battery, Body clip, Holster, Spare O-ring, Spare rubber switch boot, Charging
cable, User Manual, Warranty card
Loading...