Fellowes HS-400 User Manual

m

elp Line

7

9

5

9

es

0

0

0

0

0

1

1

4

1

0

1

65-6221-3811

6

0

Australia + 1-800-33-11-7

Canada + 1-800-665-433

éxico + 1-800-234-118

United States + 1-800-955-095

Fellow

Australia + 61-3-8336-970

Benelux + 31-(0)-76-523-209

Canada + 1-905-475-632

Deutschland + 49-(0)-5131-4977

France + 33-(0)-1-30-06-86-8

Italia + 39-(0)-71-73004

Japan + 81-(0)-3-5496-240

Korea + 82-2-3462-288

Malaysia + 60-(0)-35122-123

Polska + 48-(0)-22-771-47-4

España + 34-91-748-05-0

ingapore +

United Kingdom + 44-(0)-1302-83683

United States + 1-630-893-160

www.fellowes.co

© 2008 Fellowes, Inc. Part No. 403196 REV B

HS-400

HS-400

GLISH

SH

H

y

S

r

tha

above.

:

t

........................

)

.............................................................................

.........................................................................

00

h

...................................................

)

ps

;

.

.

.

•

.

•

•

edde

ead.

d

l

ee safety instructions belo

w

,g,

years from

the date of purchase by the original consumer. Fellowes warrants all other parts

p

y

pyg p

pyg p

the date of purchase by the original consumer. If any part is found to be defective

py

py

pyg yp

pyg yp

.

gyp,y y

gyp,y

This warranty does not apply in cases of abuse, mishandling, or unauthorized

p, p p, p

p, p p,

APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be

,

.

This warranty gives you specific legal rights. The duration, terms, and conditions of

yq g p

yq g p

this warranty are valid worldwide, except where different limitations, restrictions,

yg y p g g , ,

yg y p g g ,

y,py,

yq y

yq y

your dealer.

G

)

n

)

)

e

pp

:

)

ake sure doo

s

llow)

d

)

f

s

s

f

y

s

l

ess and hold

)

0

t

ess and hold Reverse

ds

s

s

:

s

l

)

S

S

.

y

sensors

sensor.

g

.

PERATION

isconnect Power switch must be in ON position to operate shredder. Insert waste bag (Fellowes #36052)

Control pane

redder hea

aper entr

Door

CAPABILITIE

Will shred: Pape
Will not shred: Adhesive labels, transparencies, newspaper,

redit cards, cardboard, paper clips, staples, laminates or plastic other

n noted

Paper shred size

High Security Cross-Cu

/25” x 3/16” (1 x 4.7 mm

aximum:

heets per pass
heets per day
aper entry widt

20lbs., 8.5”x11” paper at 120v, 60Hz,

humidity or other than rated voltage may reduce capacity. Recommended

aily usage rates: 2,500 sheets per day

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Auto-On (I) Off (O) Reverse (R)

Indicator lights

oor Open/Bin Ful

(yellow)

Standby (green

1/2” (241 mm

.6 Am

heavier paper,

et to Off (O

and plug i

ress Auto-On (I

eed into paper entry
nd releas

et to Off (O

ROUBLESHOOTIN

aper jam:

Press and hold

or 1-2

Reverse

econd

et to Off (O) and empty bin. Replace bin, close door, and follow any or all of the below procedures.

ndicator lights

emove all uncut

rom entr

paper

Toggle between

rward and reverse

or 5 seconds to

ean cutter

(ye

Standby (green

M
tightly closed

Remove an
empty bin (yellow

r i

AINTENANCE

Lubricate machine before

tarting to shred, after every

minutes of continous

hredding, or immediately if

• Capacity decreases

• Motor sounds different, or
hredder stops running

,5

ollow oiling procedure below and repeat twice.

r
everse (R

Apply oi
cross entry

Only use a non-aerosol vegetable oil in long nozzle container such
s Fellowes #3525

Press Auto-On (I)

hred one shee

r
R) 2-3 secon

CLEANING AUTO-START INFRARED SENSOR

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust
causing the motor to run even if there is no paper present (Note: two paper detection sensors are located in the center of the paper entry)

TO CLEAN THE SENSOR

• Keep away from children and pets.

eep hands

away from paper entry. Always set to

ff (O) or unplug when not in use

• Keep foreign objects – gloves, jewelry, clothing,
air, etc.– away from shredder openings. If

object enters top opening, switch to Reverse (R)
to back out object

• Avoid touching exposed blades under High Security Cross-Cut
hr

r h

Never use aerosol, petroleum-based or other flammable

products on or near shredder. Do not use canned air

n shredder

Do not use if damaged or defective. Do not open

shredder head. Do not place near or over heat or
water source.

4 sheets per pass to avoid jams.

• Make sure shredder gets suffi cient ventilation (ventilating grills
ust be kept free).

Locate Auto-start infared

replacement, at Fellowes’ option and expense, of the defective part

repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR

ip cotton swab in rubbin

lcohol

Using cotton swab, wipe away
an

contamination from the

5

ITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE

iable for any consequential or incidental damages attributable to this product

.