WARNINGS
IMPORTANT SAFETY INSTRUCTIONS
For Household Use Only
WHEN USING YOUR SHARK® CORDLESS VACUUM,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK®
CORDLESS VACUUM.
GENERAL ELECTRICAL SAFETY:
WARNING:
INJURY DO NOT USE OUTDOORS OR ON WET SURFACES.
1 DO NOT use or charge the unit outdoors.
2 DO NOT use or charge the unit on wet surfaces.
3 DO NOT
4 DO NOT handle vacuum, charging base or charging
5 DO NOT use charging adapter if power cord has been
6 DO NOT abuse the charging adapter cord.
7 DO NOT unplug the charging adapter by pulling on
8 DO NOT use charging adapter with an extension cord.
9 DO NOT run the vacuum over the charging adapter
10 Keep charging adapter cord away from heated
11 DO NOT attempt to use this charging adapter with any
12 Only use charging adapter provided with the vacuum. It
13 Always turn the vacuum off before connecting or
TO REDUCE THE RISK OF ELECTRIC SHOCK OR
immerse vacuum cleaner, charging base or
charging adapter
adapter with wet hands.
damaged.
NEVER carry the charging adapter or charging base by
the cord.
cord; to unplug, grasp the plug, not the cord.
Plug adapter directly and only in a standard (120V.,
60Hz) electrical outlet.
cord.
surfaces.
other product nor attempt to charge this product with
another charging adapter.
is marked “For SV1106 models only”.
disconnecting the motorized floor brush.
in water or other liquids.
GENERAL USE:
14 Use only on dry, indoor surfaces.
15 Store the cordless vacuum indoors. Put the cordless
vacuum away after use to prevent accidents.
16 Use only as described in this manual. DO NOT use for
any purpose other than described in this user’s guide.
17 Use only cleaning attachments supplied with this unit.
18 Keep your work area well lit.
19 Keep the vacuum moving over the carpet surface at all
times to avoid damaging the carpet fibers.
20 DO NOT put any objects into openings.
21 DO NOT use with any opening blocked; keep free of
dust, lint, hair and anything that may reduce airflow.
22 DO NOT
23 DO NOT vacuum up any liquids.
24 DO NOT pick up anything that is burning or smoking
25 DO NOT use to pick up flammable or combustible
26 DO NOT pick up toxic solutions such as chlorine bleach,
27 DO NOT use in an enclosed space where vapors are
28 DO NOT run the vacuum over large-sized objects.
29 DO NOT pick up hard or sharp objects such as glass,
30 DO NOT place vacuum on unstable surfaces such as
31 Use extra care when cleaning on stairs.
32 DO NOT allow the vacuum to be used as a toy.
33 Close attention is necessary when used by or near
use the vacuum cleaner without dust cup and
filter in place.
such as cigarettes, matches or hot ashes.
liquids such as gasoline or use vacuum in areas where
their fumes may be present.
ammonia or drain cleaner.
present from paint, paint thinner, moth-proofing
substances, flammable dust or other explosive or toxic
materials.
nails, screws or coins that could damage the vacuum
cleaner.
chairs or tables.
children.
34 DO NOT use cordless vacuum cleaner, charging base
or charging adapter if it has been dropped, damaged,
left outdoors or submerged in water. Return to
EURO-PRO Operating LLC for examination, repair or
adjustment.
35 Keep hair, face, loose clothing, fingers and all body
parts away from openings and moving parts.
36 This product includes rechargeable nickel metal
hydride batteries. Batteries must be recycled or
disposed of properly. Do not incinerate batteries or
expose to high temperatures as they may explode.
37 Leaks from battery cells can occur under extreme
conditions. If the liquid gets on the skin, wash
immediately with soap and water. If the liquid gets into
the eyes, flush them immediately with clean water for a
minimum of 10 minutes and seek medical attention.
38 The battery must be removed from the appliance
before the appliance is discarded.
39 Batteries are to be recycled or disposed of safely.
DUST CUP/FILTER:
40 Before turning on the vacuum:
• Make sure that the dust cup and filter are securely in
place after routine maintenance.
• Make sure that all components and filters are
thoroughly dry after routine cleaning.
• Only use filters and accessories provided by EUROPRO Operating LLC. [Failure to do so will void the
warranty.]
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
SAVE THESE
This m anual covers mod el SV1106
INSTRUCTIONS
2 TOL L FREE: 1-800-798-7398 3www.sharkclean.com
ASSEMBLY
USI NG YOUR SHARK® CORDLESS VACUUM
C
A
E
F
D
G
J
H
I
VACUUM COMPONENTS
A Main Body
B Handle
C Screw
D Dust Cup
E Dust Cup Release
F Upper Dust Cup Door Release
G Lower Dust Cup Door Release
H Motorized Brush
I Power Button
J Charging Adapter
K Charging Base
TECHNICAL SPECIFICATIONS:
Volts: 14.4
B
d
K
fig. 1
ASSEMBLY
1 Insert the vacuum body into the
motorized brush. (fig. 1a)
2 Insert the handle pole into the top
of the main body. (fig. 1b)
3 Use a screwdriver to secure the
handle assembly in place with the
bolt (taped to the handle during
shipping). (fig. 1c)
4 Ensure that the dust cup is
securely in place. (fig. 1d)
CHARGING
1 The charge adapter plug will fit
into the charging base only one
way. Insert the charging adapter
plug by aligning the arrow on the
plug with the arrow next to the
charging jack on the back of the
charging base. (fig. 2)
2 Place the vacuum on the charging
base to charge. Charge the unit
for 7 hours before using the
USE YOUR CORDLESS VACUUM
TO CLEAN BARE FLOORS,
CARPETS AND RUGS.
1 Place your foot lightly on the top
of the motorized brush and tilt the
handle back to release the unit
from the locked upright position.
b
c
a
Charging
Charge
Complete
fig. 4
fig. 2
fig. 3
3 This unit is equipped with a
precision charger that monitors
the batteries to ensure a full
charge for every use and to extend
the life of the batteries. Depending
on usage, the time for a full
charge is 4 to 7 hours.
4 One half of the blue LED light
around the power button will
illuminate while the unit is
charging. When the charge is
complete, the complete oval will
be illuminated. (fig. 4)
If the charging light does not
illuminate, ensure that the
charging adapter is plugged
in properly to the wall outlet
and to the back of the charging
base. Also ensure that the
unit is properly seated in the
charging base.
• Lightly press the power button
on the motorized floor brush
with your foot to turn the
vacuum on to a high speed
optimized for carpet cleaning.
MAXIMIZING THE LIFE OF YOUR
BATTERY
1 To enhance battery life, this vacuum
is equipped with an advanced feature
that will shut off the vacuum when
the battery is almost fully discharged.
If the vacuum shuts off while in use,
charge the unit until the complete
oval around the power button is
illuminated, indicating a full charge.
2 Charge the vacuum for 7 hours
before initial use. After initial use,
each recharge will take 4 to 7 hours.
A complete oval around the power
button will illuminate when the charge
is complete.
3 The precision charger monitors the
batteries so you don’t have to. A
complete charge can take as little as
4 hours, but may take up to 7 hours
because the charger monitors battery
properties to extend batter y life.
Leaving the unit in the charger past
the complete charge time will NOT
harm the batteries.
4 If the vacuum has never been used
or has not been used for an extended
period of time, it will take 3 to 5
complete charge and run down cycles
to realize the full operational time of
the vacuum.
5 Do not store or charge in areas of high
temperature or humidity.
6 Use only the charge adapter supplied
with this unit, marked with “For
SV1106 Model Only”. If other chargers
are used, the battery can fail causing
damage to the battery, to the vacuum,
or to personal property.
Call customer service at 1 (800) 798-7398 or visit our web site at www.sharkclean.com to order a replacement battery pack.
On this setting, the vacuum
will run for approximately 12
minutes.
• Press the button again to switch
to a lower speed optimized for
bare floor cleaning. On this
setting the vacuum will run for
approximately 17 minutes. The
LED lights around the power
button will indicate your speed.
• Press the button again to turn
the unit off.
BATTERY RECONDITIONING
If you experience shorter run time over the
life of the vacuum, perform the following
battery reconditioning steps. These
steps can also be performed as monthly
maintenance for maximum battery life.
1 Charge the vacuum for a minimum of 7
hours.
2 Run the vacuum until it turns itself off.
3 Charge the vacuum for a minimum of 7
hours.
BATTERY REMOVAL, REPLACEMENT
AND DISPOSAL
The cordless vacuum is powered by Ni-Mh
batteries, which must be recycled or
disposed of properly in accordance
with state, federal and local laws. If
uncertain as to how to remove the battery
pack, we suggest that you take your
vacuum to a reputable small appliance
service technician to have this service
performed.
BATTERY REMOVAL
1 Ensure that the unit is Off.
2 Never open the battery compartment
except to replace or dispose of the
battery pack.
3 The battery door is on the bottom of
the floor nozzle. Turn the unit over and
push the sliding tab located next to the
battery door to the unlock position.
Slide and lift the battery door off of the
nozzle.
4 Remove the battery pack by pulling on
the battery strap.
5 Grasp the white connector terminals
and push down on the lever with your
thumb. Pull to disconnect.
IMPORTANT: The indicator light
around the power button will
flash if the brush roll stops
due to a jam. This feature is
designed to protect the Lifetime
Belt that powers the brushroll.
See “Restarting After a Jam” on
page 8.
BARE FLOOR
CARPET
BATTERY REPLACEMENT
1 Push the connector terminals together
until they click into place.
2 Replace the new battery pack into the
battery compartment, taking care to
tuck the wiring completely in so that
the wiring does not interfere with the
battery access door.
3 Place the battery door onto the bottom
of the nozzle, slide it back into place
and move the sliding tab next to the
door to the lock position.
CAUTION:
• Use only with battery pack supplied.
• Never use ordinary batteries for
replacement as these may leak and
damage your vacuum
• Do not attempt to remove the battery
pack from the unit to charge.
• Never throw the battery pack or the
appliance into a fire or incinerate it.
• Do not remove or damage the battery
casing.
• Do not place the batteries on metal
surfaces.
• Do not touch metal parts of the
batteries together as the batteries will
overheat.
vacuum for the first time. (fig. 3)
4 TOL L FREE: 1-800-798-7398 5www.sharkclean.com