Epson Stylus NX625 Start Here

Epson Stylus® NX620/625 Series

Select language

3

Start Here

Read these instructions before using your product.

Unpack

1

French control

Power cord

Caution: Do not open ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials.

panel stickers

To select English as your language, press OK.

Note: If you want to change the language, press or to select it,

then press OK.

Install ink cartridges

4

1 Lift up the scanner, then open the cartridge cover.

Turn on and adjust

2

1 Connect the power cable.

Caution: Do not connect to your computer yet.

2 Press the On button, then raise the control panel.

2 Shake the ink cartridges gently 4 or 5 times, then

unpack them.

3 Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

To lower the control panel, press the release bar underneath

and push the control panel down.

Caution: To avoid damaging your Epson Stylus NX620/625 Series,

always press the release bar to lower the control panel.

*411835000*

*411835000*

4 Insert the cartridges in the holder for each color.

5 Press each cartridge down until it clicks.

6 Close the cartridge cover. Press down until it clicks. Then

lower the scanner.

3 Slide the edge guide to your paper size.

4 Load paper against the edge guide, with the glossy or

printable side face-down.

Note: Make sure the paper is loaded against the edge guide

and not sticking out from the end of the cassette.

5 Slide the edge guides against the edges of the paper,

but not too tightly.

7 Wait while the ink delivery system primes. Priming takes

about 5 minutes.

Note: Your printer ships with full cartridges and part of the ink from

the first cartridges is used for priming the printer.

Caution: Don’t turn off the printer while it is priming or you’ll

waste ink.

Load paper

5

1 Pull out the paper cassette.

2 Slide the edge guides to the sides of the cassette.

6 Keep the cassette fl at as you insert it.

Note: The paper may slide forward slightly as you insert the

cassette. This is normal.

7 Extend the output tray and fl ip up the paper stopper.