Epson Stylus NX510 Start Here

*411638300*

*411638300*

If anything is missing, contact Epson as described on the back.

Note: The model name of your product may vary slightly from the one shown above.

The included CD and documentation apply to all products in the series.

Caution: Do not open ink cartridge packages until you are ready to install the ink.

Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove sticker(s) from the backing sheet and
place over corresponding text on the control panel.

Remove all protective materials.

Unpack

1

Start Here

(Included for

Canada only)

1 Connect the power cable.

Caution: Do not connect to your computer yet.

2 Raise the display screen, then press the On button.

Turn on and adjust

2

Power cord

Series

3

Press or to select your language, then press OK.

4

Note: Do not load paper yet.

1 Lift up the scanner, then open the cartridge cover.

Select language

Install ink cartridges

2 Shake the ink cartridges gently 4 or 5 times, then unpack them.

3 Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

4 Insert the cartridges in the holder for each color.

5 Press each cartridge down until it clicks.

6 Close the ink cartridge cover. Press it down until it clicks.

7 Lower the scanner.

8 Press the OK button to charge the ink. Charging takes about 3 minutes.

Note: Your NX510 Series ships with full cartridges and part of the ink from the

first cartridges is used for priming the NX510 Series.

Caution: Don’t turn off the NX510 Series while the ink system is charging or

you’ll waste ink.

5

1 Open the paper support and pull up the extensions.

Load paper

2 Open the output tray, pull out the extensions, and raise the stopper.

Note: If you are using legal-size paper, do not raise the stopper.