Epson Stylus NX305 Start Guide

Start Here

Stop/

Clear Settings

B&W

Color

Fax

Epson Stylus® NX300/305 Series

*411852500*

*411852500*

Read these instructions before using your product.

Unpack

1

Make settings

3

1 Press or to select your language, then press OK.

2 Press or to select your country or region, then press

OK.

3 Press or to select Summer if your region uses Daylight

Saving Time and it’s currently in effect. (DST is effective from
spring through summer.) Otherwise select Winter to turn off
the setting.

Power cord

Caution: Do not open the ink cartridge package until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials.

Turn on

2

1 Connect the power cable.

USB cable

4 Press OK.

5 Press or to select the date format, then press OK.

6 Use the numeric keypad to change the date, then press OK.

7 Press or to select a 12-hour or 24-hour time format,

then press OK.

8 Use the numeric keypad to set the time.

If you chose a 12-hour time format, press or to select

AM or PM.

9 Press OK.

Install ink cartridges

4

1 Lift up the scanner.

Caution: Do not connect to your computer yet.

2 Press the On button.

2 Open the cartridge cover.

3 Shake the ink cartridges, then unpack them.

4 Remove only the yellow tape from each cartridge.

Load paper

5

1 Open the paper support and pull up the extensions.

Caution: Don’t remove any other seals from the cartridges.

5 Insert the cartridges in the holder for each color.

6 Press each cartridge down until it clicks.

2 Open the output tray, pull out the extension, and raise the

paper stopper.

3 Pinch the edge guide and slide it to the left.

4 Load paper against the right edge guide and behind the

tab, with the printable side face up.

7 Close the ink cartridge cover and press it down until

it clicks.

8 Lower the scanner.

9 Press the OK button to charge the ink. Charging takes

about 2 minutes.

Note: Your printer ships with full cartridges and part of the ink

from the first cartridges is used for priming the printer.

Caution: Don’t turn off the printer while it is charging or you’ll

waste ink.

8½ x 11

4 x 6

Note: Don’t load the paper sideways; always

load it short edge first.

5 Slide the edge guide over.