Epson Stylus NX200 Quick Start Manual

Epson Stylus® NX200 Series

Start Here

1

Turn on the NX200 Series

1 Connect the power cable.

Note: Do not connect to the computer at this time.

2 Press the On button.

Unpack

If anything is missing, contact Epson as described on the back.

Caution: Do not open the ink cartridge package until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove the control panel sticker(s)
from the backing sheet and place over the corresponding text on the
control panel.

2

(Included for Canada only)

3

Note: Do not load paper yet.

1 Lift up the scanner, then open the cartridge cover.

2 Shake the ink cartridges, then unpack them.

Install cartridges

3 Remove only the yellow tape from each cartridge.

Caution: Do not remove any other seals or the cartridge may leak.

4 Insert the cartridges in the holder for each color.

5 Press each cartridge down until it clicks.

6 Close the cartridge cover. Press down until it clicks.

7 Lower the scanner.

8 Press the Stop button to charge the ink. Charging takes about

21/2 minutes.

Caution: Don’t turn off the NX200 Series while it is charging or you’ll

waste ink.

Load paper

1 Open the paper support and pull up the extensions.

2 Open the output tray, pull out the extensions, and raise the stopper.

4