Epson Stylus NX127, Stylus NX125 Start Here

Epson Stylus® NX125/127 Series

Install ink cartridges

Start Here

Read these instructions before using your printer.

Epson Stylus NX125/127

Series

Quick Guide

Basic Copying, Printing, and Scanning

Maintenance

Solving Problems

Power cord

Caution: Do not open the ink cartridge package until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials.

1 Open the document cover, then open the ink cover.

Caution: Don’t try to remove the ink cartridge guard or you may

damage the printer.

2 Shake the ink cartridges, then unpack them.

3 Remove only the yellow tape from each cartridge.

1 Connect the power cable.

Caution: Do not connect to your computer yet.

2 Press the power button.

Caution: Don’t remove any other seals from the cartridges.

4 Insert the cyan ink cartridge, and press it down until it clicks.

5 Press the stop button. The cartridge holder moves.

6 Repeat steps 4 and 5 for other cartridges.

7 Close the ink cover, then close the document cover and

press the stop button again.

8 Ink priming takes about 2 minutes. When the green power

light stops blinking, priming is complete.

2 Lower the output tray, then open the extension.

3 Flip the feeder guard forward.

Note: Your printer ships with full cartridges and part of the ink

from the first cartridges is used for priming the printer.

Caution: Don’t turn off the printer while it is priming or you’ll

waste ink.

1 Open the paper support, then pull up the extension and tilt

it back slightly.

4 Squeeze the edge guide and slide it to the left.

5 Load paper against the right edge guide and behind the

tab, with the printable side face up.

8½ x 11

4 x 6

+ 2 hidden pages