Epson RS-232 User Manual

Installer Guide

Follow these instructions to set up the Epson PowerLite

®®

Pro Cinema projector and HQV Video Processor

1. Unpack the projector and video processor. Attach the serial number sticker included with

the video processor to the User Manual for that product.

2. Choose a location for the projector as described in the projector User’s Guide.

3. Connect an HDMI cable from the video processor to the projector.

RS-232 (SLAVE)

Video processor

Projector

HDMI OUT

4. If you want the video processor to be able to turn the projector on or off, connect an
9-pin, null-modem RS-232 cable from the video processor to the projector.

5. Plug in the power cord for the video processor. Make sure batteries are installed in the
video processor remote control.

6. Turn on the power switch on the back of the video processor (above the AC power inlet).

7. After a few moments, the display on the front of the unit should show Output=720P

60Hz

.

If it does not, press the

POWER button on the remote control to place the video

processor in Setup Mode. (You see Setup Mode on the display.)

Press the

Menu button. Then use the u and d buttons to select the output

resolution setting (“OUT = xxx”). Use the l and r buttons to change the setting

OUT = 720p 60 Hz.

to

Press the

POWER button on the remote control to return the video processor to On

Mode.

8. Remove the protective lens pad from the projector, then remove the lens cap.

9. Plug in the power cord. Make sure batteries are installed in the projector remote control.

10. Turn on the power switch on the back of the projector, then press the

On button on the

remote control.

2

Turn on the
projector

Power switch