Epson Stylus®Photo R320
Start
Start
Here
Here
Epson Stylus Photo R320
1
1
1 Remove everything from the box.
Unpack
Unpack
CPD-18377
4050614-00
XXX
Small CD
insert
Ink cartridges
Quick Reference
CD position
check paper
Printer
Printer Software
2 Remove all the tape and
packing material from
the printer.
3 Open the output tray and the printer cover.
Then remove the tape.
Make sure the CD/DVD tray guide
is closed completely.
CD-ROM
CD/DVD tray
Printer Basics
Make sure the tray guide is
up after removing the tape
Turn On the Printer
2
2
1 Plug the printer’s power cord into a grounded electrical outlet.
STOP: Do not connect the printer to your computer yet. Wait until you are instructed
to connect the USB cable in section 5, “Install Software.”
2 Press the Power button to turn on the printer.
Turn On the Printer
CAUTION: Never use an external switch, such as a wall switch or power strip switch,
to turn the printer on or off.
3
3
1 Flip open the paper support and pull up the extension.
Install the
Install the
Ink Cartridges
Ink Cartridges
2 Open the printer cover.
continue
3 Unwrap the ink cartridges.
Don’t touch the green circuit
board or remove any labels
4 Open the cartridge cover and remove the paper insert.
5 Lower each cartridge into its holder with the green circuit board facing the front.
The color of the cartridge label should match the marker above the cartridge holder.
Then gently push each ink cartridge down until it is firmly seated.
6 Close the cartridge cover.
7 Press the Maintenance button and close the printer cover.
CAUTION: Don’t turn off the printer or interrupt charging while the light is flashing or
you’ll waste ink.
A progress bar is displayed on the LCD panel during ink charging.
8 After ink charging is finished, press OK.
4
4
1 Fan a few sheets of paper and load them against
the right side of the sheet feeder.
2 Slide the left edge guide against the paper.
NOTE: For instructions on loading and printing
on CDs or DVDs, see your Printer Basics book.
Load Paper
Load Paper
5
5
Windows
The software works with Windows 98SE, Me, 2000, and XP. Make sure your printer is NOT
connected to your computer, then follow the steps below.
1 Turn on your computer. Wait for the system
to start up, then insert the Epson®CD-ROM
in your drive.
Install Software
Install Software
®
NOTE: If you see a screen like this,
click Cancel and disconnect the
printer from your computer. Then
follow the steps below.
2 Read the license agreement that appears
and click AGREE.
3 You see a message like this:
Click OK to begin installing your printer driver.
4 When you see this screen, connect the square
end of your USB cable to the back of the printer and
the flat end of the USB cable to your
computer. (You can connect to any open port.)
NOTE: For Windows XP, if you don’t have USB 2.0,
you see a message. Click the Close button to close
the message.
Square end
Wait while Windows detects your hardware.
5 When you see this screen, click Continue.
6 Follow the on-screen instructions to
install your software.
Flat end
continue
7 When installation is complete, you see this screen:
Click each title to learn more about it. If you want to
install the software, follow the on-screen instructions.
8 When you’re done installing software, click Exit. The
registration screen appears.
9 Follow the on-screen instructions to register your printer.
10 When you see a message telling you to restart your computer, click OK.
Remove the CD, then restart your computer.
NOTE: Be sure to restart your computer to enable all of your printer software features.
You’re ready to print! See section 6, “Print.”
Macintosh
The software works with Mac OS®9.2.x, and Mac OS X 10.2.x through 10.3.x.
®
1 Connect your printer to your computer: connect the square end of your USB cable
to the printer and the flat end of the USB cable to your computer. (You can connect
to any open port.)
Square end
Flat end
2 Turn on your Macintosh. Wait for it to start up,
then insert the Epson CD-ROM in your drive.
3 Double-click the CD-ROM icon, if necessary,
then double-click EPSON.
4 Read the license agreement that appears
and click AGREE.
You see the Install Menu.
5 Click Install Printer Driver and Utilities and follow
the on-screen instructions. (In Mac OS X, you will need
to enter your Administrator password for each item.)
6 Click Install EPSON Print CD, then click Install
and follow the on-screen instructions.
NOTE: EPSON Print CD is not available for
Mac OS 9.
7 Click Install Optional Software.
You see the following menu:
8 Click each title to learn more about it. If you want to
install the software, follow the on-screen instructions.
9 When you’re finished installing software, close any
open windows on the screen and click Back at the
Optional Software menu.
10 From the Install Menu, click Install Printer Manual to install your on-screen
Reference Guide.
11 When you’re done installing software, click Exit. The registration screen appears.
12 Follow the on-screen instructions to register your printer.
Go to the section for your operating system to finish setting up your printer.
continue
Mac OS X 10.2.x through 10.3.x
1
Open the Applications folder, then open the Utilities folder and select Print Center, or
Printer Setup Utility.
If you see this screen, click Add.
2 On the Printer List screen, click the Add button.
3 On the next screen, select USB from the pop-up menu.
4 Click Stylus Photo R320.
NOTE: If the Stylus Photo R320 doesn’t
appear, make sure it is turned on and securely
connected to your Macintosh.
5 Click the Add button. You see the Stylus Photo R320
in the Printer List.
6 Quit Print Center or the Printer Setup Utility.
NOTE: Be sure to restart your Macintosh to
enable all of your printer software features.
You’re ready to print! See section 6, “Print.”
Mac OS 9.2.x
Open the Chooser from the Apple®menu, then select these options:
• SP R320 Series
• Your USB port
• Background printing (on or off)
Close the Chooser.
NOTE: Be sure to restart your Macintosh to
enable all of your printer software features.
You’re ready to print! See section 6, “Print.”
6
6
Now you’re ready to print. For instructions, use these resources:
• Your Printer Basics book
Learn about loading paper, printing, maintaining your printer,
solving problems, and contacting Epson.
• Your Quick Reference card
See how easy it is to print without a computer.
• Your on-screen Reference Guide
Double-click the ESPR320 Reference Guide icon on your desktop
to view more information about your printer.
Print
Epson and Epson Stylus are registered trademarks of Seiko Epson Corporation.
General Notice: Other product names are for identification purposes only and may be trademarks of their respective owners.
Epson disclaims any and all rights in those marks.
© 2004 Epson America, Inc. 7/04
Printed in XXXXXX XX-XX.XX
Loading...