Epson NX400 User Manual

Epson Stylus® NX400 Series

Start Here

Unpack

If anything is missing, contact Epson as described on the back.

Caution: Do not open the ink cartridge package until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.

Canada only: For French speakers, remove stickers from the backing sheet
and place over corresponding text on the control panel.

1

Turn on the NX400 Series

1 Connect the power cable.

Note: Do not connect to the computer at this time.

2 Press the On button.

2

(Included for Canada only)

3

Note: Do not load paper yet.

Install cartridges

1 Lift up the scanner.

2 Open the cartridge

cover.

3 Shake the ink cartridges,

then unpack them.

4 Remove only the yellow tape from each cartridge.

Caution: Do not remove

any other seals or the
cartridge may leak.

5 Insert the cartridges in the holder for

each color.

6 Press each cartridge down until it clicks.

7 Close the cartridge cover. Press down until

it clicks.

8 Lower the scanner.

9 Press the OK button to charge the ink. Charging takes about

2½ minutes.

Caution: Don’t turn off the NX400 Series while it is charging or you’ll

waste ink.

Load paper

1 Open the paper support and pull up the extensions.

2 Open the output tray, pull out the extensions, and raise the stopper.

5

Change your language

You can change the language that appears on your LCD display screen
from English to French, Spanish, or Portuguese.

1 Press Setup.

2 Press to select Maintenance, and press OK.

3 Press to select Language, and press OK.

4 Press or to select your language, and press OK.

4