Epson LS57P1 Supplemental Information

®
HDTV LCD Projection Television
Installing and Maintaining the Optional Front Air Filter
Follow these instructions to install and maintain the optional front air filter for your Epson® LivingStation® television. This filter is intended for customers who live in dry, dusty areas to reduce the amount of dust that enters the TV.
Caution
Installing the Filter
Follow these steps to install the new filter:
1 Remove the right speaker cover. Grasp the cover and pull it straight off.
2 Remove the adhesive backing from the filter.
Remove cover
Remove adhesive backing
3 Align the slot in the filter with the tab on the TV. Press the filter in place over the air intake vent.
Align slot with tab on air intake vent
4 Press down on the filter to make sure the adhesive is secure.
Make sure adhesive is secure
5 Replace the speaker cover.
Cleaning the Air Filter
Once the air filter is installed, you need to inspect it regularly. If the filter appears to be dirty, clean it as described below.
Note
Whenever you inpect the front air filter, you should also check the air filter on the left side of the TV and clean it if necessary. The location of this filter is shown in your User’s Guide. You can clean the side filter using the same method that you use to clean the front filter.
1 Remove the right speaker cover.
2 If the filter looks dirty, clean it using one of these methods:
Use a computer vacuum cleaner or the upholstery brush attachment for your home vacuum cleaner to lightly vacuum the filter and remove the dust. If your home vacuum cleaner has an air bleed valve (located near the end of the hose where you attach the cleaning tools), you should open the valve to decrease the amount of suction.
Use a clean paintbrush with very soft bristles to lightly brush off any dust from the crevices.
3 Replace the speaker cover.
Epson and Livingstation are registered trademarks and Epson Exceed Your Vision is a trademark of Seiko Epson Corporation.
© 2007 Epson America, Inc. 7/07 CPD-24509
Loading...