Epson ELPIU03 User Manual

Interactive Unit

User's Guide

Important Safety Instructions

• Make sure you read the Quick Setup Guide and follow the instructions in this document to install the Interactive Unit.

• Keep the Quick Setup Guide for future reference.

Explanation of Symbols

Warning

Caution

This symbol indicates information that, if ignored, could possibly result in personal injury or even death due to incorrect handling.

This symbol indicates information that, if ignored, could possibly result in personal injury or physical damage due to incorrect handling.

Installation Precautions

Warning

• Attachment to the projector should be performed by qualified technicians using only approved mounting equipment.

• Follow the instructions in the Quick Setup Guide when installing the Interactive Unit. Incomplete or incorrect installation could cause the product to fall and cause

personal injury or property damage.

• If you apply adhesives to prevent the screws from loosening, or if you use lubricants or oils on the wall plate, the housing may crack and cause the product or the
projector to fall, resulting in personal injury or property damage.

• Confirm on a regular basis that the screws have not become loose. If you find any loose screws, tighten them firmly. Otherwise, the product or wall plate may fall and
cause personal injury or property damage.

• Handle the USB cable carefully to avoid fire or electric shock. Observe the following precautions when handling:

- Do not handle the cable with wet hands.

- Do not use a cable that is damaged or modified.

- Do not pull the cable with too much force when routing it or connecting it to a computer.

• Do not apply excessive force to this product when adjusting the projector. Otherwise, the product may cause personal injury.

Caution

Do not install the product in a location where there is excessive humidity or dust, near cooking or heating appliances, or in a location exposed to smoke or steam. Fire or
electric shock may result.

Usage Precautions

Warning

• Water infiltration or deterioration and breakage of the product housing could result in electric shock.

• Never open any covers on the product except as specifically explained in this User's Guide. Never attempt to disassemble or modify the product (including consumables).

Refer all repairs to qualified service personnel. Electrical voltages inside the product can cause severe injury.

• Disconnect the USB cable and refer all repairs to qualified service personnel under the following conditions:

- If smoke, strange odors or strange noises come from the product.

- If liquid or foreign objects get inside the product.

- If the product has been dropped or the housing has been damaged.
Continuing to use the product under these conditions may result in fire or electric shock.

Caution

• Use a dry cloth for cleaning (or, for stubborn dirt or stains, a damp cloth that has been wrung dry). Do not use liquid, aerosol cleaners, or solvents such as alcohol,
thinner, or benzine.

• Do not put anything that exceeds the weight of two Easy Interactive Pens in the pen tray.

Battery Precautions

Warning

• If liquid leaking from the batteries gets into your eyes, do not rub your eyes. Wash them immediately with clean water and consult a doctor.

• If liquid from the battery enters your mouth, rinse immediately with plenty of water and consult a doctor.

• If liquid from the battery comes in contact with your skin or clothes, wash immediately with water. Battery liquid may cause skin damage.

• Do not leave the batteries or the Easy Interactive Pen inside a vehicle with the windows closed, in places where they will be exposed to direct sunlight, or in places that

may become extremely hot. Thermal deformation or technical malfunction may occur, which could result in fire.

• Keep batteries out of the reach of children. Batteries are choking hazards and are very dangerous if swallowed.

• Insert batteries so that the polarities (+ and -) are correctly aligned, to avoid leakage, overheating, or explosion.

• Do not mix old and new batteries, or batteries of different types. Doing so may cause leakage, overheating, or explosion.

• Replace batteries as soon as they run out. If a dead battery is left inside the pen for long periods, gas emitted from the battery may cause leakage, overheating, explosion,

or damage to the device.

• Remove the batteries if you will not be using the pens for a long period of time.

Infrared Precautions

Caution

Because this product uses infrared communication, it could interfere with infrared communication from other product(s). If this does happen, move the other product(s) out
of the detection area.

Contents

6

Important Safety Instructions ........................ 2

Introduction

Product Features ........................................... 8

Parts Location .............................................. 9

Interactive Unit................................................ 9

Easy Interactive Pen .............................................9

Pen Tray....................................................10

Getting Started

Installing the Software ..................................... 12

Installing the Pen Batteries ................................. 13

Connecting the Cables ..................................... 14

Using the Easy Interactive Pen

Calibrating ................................................ 16

Checking the Connection Status................................... 16

Performing Calibration..........................................16

Using the Pen as a Mouse ................................... 18

Solving Problems

Problems and Solutions .................................... 21

Easy Interactive Pen Problems ..................................... 21

Calibration Problems ...........................................21

Tablet Function Problems ........................................ 21

Where to Get Help ......................................... 22

Notices

Specifications ............................................. 24

General ....................................................24

Dimensions.................................................24

Electrical................................................... 24

Environmental............................................... 24

Easy Interactive Pen ............................................ 24

System Requirements.......................................... 25

FCC Compliance Statement . . . . . ............................ 26

For United States Users .........................................26

WARNING................................................... 26

For Canadian Users ............................................26

Declaration of Conformity .................................. 27

Copyright Notice .......................................... 28

Trademarks ................................................. 28

Tablet Function ............................................ 19

System Requirements.......................................... 19

Checking Availability...........................................19

Introduction

The Interactive Unit is a wall-mounted receiver that works with your projector to turn virtually any surface into an interactive whiteboard. You can use it with
your projector and whiteboard. The Interactive Unit includes all the hardware and software you need to create interactive presentations using your computer
and installed projector.

Product Features

By using the Interactive Unit, you can use your existing projector as an
electronic blackboard. When used in combination with your projector, the
following functions become available.

• Electronic Blackboard Function
When projecting a computer screen from the projector, you can use the
Easy Interactive Pen as a mouse. By giving the presenter the ability to
perform computer operations on the projected image, lessons or

presentations can be moved along smoothly.

• Drawing Function
If you installed the optional Easy Interactive Tools, you can use the Easy
Interactive Pen to write or draw on the projected image. You can also
save what you wrote to your computer.

You can download Easy Interactive Tools from the Epson website at

a

http://www.epson.com.

8

Parts Location

9

Interactive Unit

Name Function

Easy Interactive

A

Function receiver

USB cover

B

Receives signals from the Easy Interactive Pen.

Covers the USB cable connection.

Easy Interactive Pen

Name Function

Battery indicator light

A

Button

B

Cord attachment slot

C

When you press the button, the light turns green if there is
any remaining battery power.

If it does not turn green, replace the batteries. s p.13

Functions as the right button of a mouse.

You can attach a commercially available cord or strap.