E-Pos Magnum User Manual

E -P os

Magnum

User Manual

TABLE OF CONTENTS

Introduction - 1

Table of Contents - 3

Location - 4

Do’s & Don’ts - 5

Accessories - 6

General Information - 7

Specifications - 8

Jumper Settings - 11

Connectors - 14

Hardware Installation - 15

Software Driver Installation - 20

LOCATIONS

Corporate Head Quarters

Middle East

E-PoS International
LLC
P.O.Box 12608
Dubai, UAE

Tel: [phone]
Fax: [phone]
Email:
[e-mail]

South East Asia Head Quarters

South East
Asia

E-PoS International
Nasik-Pune Road
Ayodhya Nagri
Nasik, Maharasthra
India

Tel: [phone]
Fax: [phone]
Email:
[e-mail]

DO’S & DON’TS

(Integrated circuits on All E-PoS System boards are sensitive to static electricity.

To avoid damaging any Components on the computer board, before getting

started, read these following precautions and other instructions and save them for

later reference).

i. Do not remove the computer from the anti-static Packaging until you are ready for

installation.

ii. Make sure the voltage of the power source is correct before connecting the

computer to the power outlet, (110~220 volts).

iii. Connect Rubber Legs provided to avoid damaging Cabinet Cover and Door,

(where provided).

iv. Do not change any Hardware Devices online when System or the device is on and

running, because the sudden surge of power may ruin any sensitive components.
Also make sure the computer is properly grounded.

v. Turn off the computer before cleaning. Always clean with a damp or dry cloth

only. Do not spray any liquid cleaner on screen directly.

vi. The power outlet socket used to plug in the computer power cord must be located

near the system and easily accessible. Do not use outlets on the same circuit of the
system that regularly switch on and off.

vii. If the computer is sharing an extension cord with other devices, make sure the

total ampere rating of the devices plugged into the extension cord does not exceed
the cord’s ampere rating.

viii. Do not expose the power cord, extension cord and power outlet to moisture.

ix. The openings on the computer enclosure are for the cabin ventilation to prevent

the computer from overheating. DO NOT COVER THE OPENINGS.

x. Do not connect any devices to Powered COM Ports (5V/12V), other then the

devices that take power from Powered COM Ports to avoid damaging the Device.

xi. Any Hardware upgrades or changes to be made are to be informed, and do not

tamper with Serial Nos. and Warranty Seals, to avoid Warranty Void.

xii. If the computer is not equipped with an operating system. An operating system

must be loaded first before installing any software into the computer.

xiii. If the computer is equipped with a touch panel, avoid using sharp objects to

operate the touch panel. Scratches on the touch panel may cause mal-calibration
or non-function to the panel.

xiv. The LCD panel display is not subject to shock or vibration. When assembling the

computer, make sure it is securely installed.

xv. Choose an Ideal dust free location and reliable surface for the System with proper

ventilations.

ACCESSORIES

1. Warranty Card.

2. Power Cable.

3. Driver Bank CD.

4. CD Connection Kit.

5. PC Stand (4 Pcs).

6. Modem Cable (Optional)

General Information

__________________________________________________

The

E-POS MAGNUM

is an Intel Celeron / Pentium III (Socket

370) Multimedia ATX motherboard with LCD/VGA controller, Ethernet 100/10,
AC97 sound, and IDE flash disk. By integrating single chip, SiS630ST, the
E-POS MAGNUM provides a high performance / low cost desktop solution.

Highly integrated, the E-POS Magnum can adapt Intel. Celeron
(66MHz) and Pentium III (100/133MHz) CPU. Onboard features include four
serial ports, two multi–mode Parallel ports, a floppy drive controller and a PS /
2 keyboard PS / 2 mouse interface. The built-in high speed PCI IDE controller
supports both PIO and ATA 100 mode. Up to four IDE devices can be
connected, including large hard disks, CD-ROM drives and other IDE devices.

The full PC functionality coupled with its multi-I/Os stand ready to
accommodate a wide range of PC peripherals. Compact in size and with its
highly integrated multimedia and networking functions, the E-POS Magnum is
the most powerful PC engine to build any small footprint all-in-one PC system
for integration into any space-constricted embedded applications. Fully
configurable and with its modular design, the E-POS Magnum is an ideal
platform for any consumer computing applications where space is a premium.

Specifications

__________________________________________________

E-POS MAGNUM

:
Multimedia I nt el Celeron/Pentium III FLEX AT X Motherboard with
XGA, LCD, TV- out, Dual display, Ethernet & Audio I nter face

CPU

:

I ntel Socket 370

I ntel T ualatin FCPGA up to 1 . 26GHz
I ntel Pentium III FCPGA 66/100/133 up t o 1 GHz
Celeron FCPGA 66/100 up to 1. 3 GH z

Main Chipset

: SiS630ST

Super I/O

:

Winbond W83697HF & W83627F

•

W83697HF: UART1, UART 2, Parallel Port 1 FDC, Game/MI DI,

I R/CI R, Hardware Monitor

•

W83627F: UART3, Parallel Port 2, UART4 (Pin 1/9 power

s uppor t )

System BIOS

: Award Pn P Flash BI OS

System Memory

:

2 x 168 pin DI MM s ock et s suppor t ing S DRAM up to 1GB

L2 Cache

: CPU built- in

Standard I/O

•

S er ial ports x 4: COM 1 ~ 4, COM 2 & 4 with + 5V/12 power

output on pin # 9

•

Par allel port x 2: Suppor t S PP/E PP/ECP;

•

AT A 100/66 I DE x 2: suppor t s up t o 4 I DE devices

•

FDD x 1: suppor t s up t o 2 floppy disk drives

•

PS /2 Keyboard I nt er face x 1

•

I nternal Keyboard I nt er face x 1

•

PS /2 Mouse I nt er face x 1

•

US B Interface x 4: 2 internal and 2 external