MODEL: HK105
LED DIGITAL ALARM CLOCK
1976, 2001 Sanrio Co., Ltd.
C
Welcome to the world of Hello Kitty. My friends at Emerson Radio Corp. are producing this Hello Kitty Digital Alarm Clock under
license from Sanrio Company Ltd. Please read these instructions carefully and completely to make sure that you are familiar
with the operation of this product. If you have any diff iculty with the set up or operation of this product please call my friends at
Emerson Radio toll free at 1-800-898-9020.
1. AM Indicator.
2. ALM(Alarm ON) Indicator.
3. Time LED Display.
4. Battery Compartment.
(at bottom of cabinet)
5. AC Power Cord.
6. SNOOZE Button(Doll).
7. Alarm ON / OFF Button.
8. ALARM / RESET Button.
(Alarm Time Adjustment)
9. HOUR Button.
10. MINUTE Button.
11. TIME Adjustment Button.
SURE-ALARM BATTERY BACK UP SYSTEM
This alarm clock has a Sure-Alarm battery back up system that will maintain the time and alarm settings in the event of a temporary
power interruption. In addition the battery can still operate the alarm even if the power is 'Off' at the wake up time.
Open the battery compartment cover on the bottom of the cabinet and
attach a 9 volt battery, (not included) to the battery terminal. It can only
be attached one way. Use an alkaline battery for longest life. Push the
battery into the compartment and close the cover.
If the power is interrupted the display goes ‘Off’. However, the battery will maintain the time and alarm settings, and when the power is
restored the display will come on again and the time and alarm settings will be correct.
If there is no battery, or a dead battery, in the battery compartment and the power is interrupted, the clock and alarm settings will be lost.
When the power is restored the clock display will be flashing. This indicates that the time display is incorrect and that both the time and
alarm time must be reset.
A fresh 9 volt alkaline battery should last for at least one year, but this depends on the number and duration of the power interruptions
you experience. For best performance we recommend that you install a new battery every 12 months.
POWER SUPPLY
This alarm clock is designed to operate on 110V-120V 60 Hz AC house current only. It should be connected to an AC outlet that is always
"live". Do not connect it to an outlet that is controlled by a wall switch.
This unit has a polarized AC plug with one wide blade and one narrow blade.This plug will only
fit into a matching polarized AC outlet. This is a safety feature to reduce the possibility of electric
shock. If this plug will not fit in your AC outlet, you probably have an outdated non-polarized
outlet. You should have your outdated outlet changed by a qualified, licensed electrician. Do not
file the wide blade on the plug, or use an adapter to make the plug fit into your outlet. This
defeats the safety feature and could expose you to electric shock.
LOCATION OF CONTROLS AND INDICATORS
12 3 4 5
678 11109
Part No.: 16-2816
109-02
Printed in China
SETTING THE TIME
After installing the back up battery, unwind the AC cord completely and connect the plug to your AC outlet. The display will show "12:00"
and begin to flash.
1. Depress the TIME and HOUR buttons to adjust the hours. Release the buttons when the correct hour appears on the display.
NOTE: Be sure to observe the AM indicator when adjusting the hours. If the AM indicator is 'On' the hour displayed is AM. If the AM
indicator is 'Off', the hour displayed is PM.
2. Depress the TIME and MINUTE buttons to adjust the minutes. Release the buttons when the correct minute appears on the display.
SETTING THE WAKE-UP TIME
1. Depress the ALARM / RESET and HOUR buttons to adjust the hours. Release the buttons when the correct wake-up hour appears on
the display.
NOTE: Be sure to observe the AM indicator when adjusting the hours. If the AM indicator is 'On' the hour displayed is AM. If the AM
indicator is 'Off', the hour displayed is PM.
2. Depress the ALARM / RESET and MINUTE buttons to adjust the minutes. Release the buttons when the correct wake-up minute
appears on the display.
SETTING THE ALARM
1. Depress the ALARM / RESET button to check the wake-up time setting. When the button is depressed the display will change from the
actual time to the wake-up time. Adjust the wake-up time setting if necessary.
2. Set the Alarm ON
/ OFF switch to the 'ON' position. The ALM(Alarm ‘On’) Indicator appears in the display.
3. At the selected wake up time the electronic 'buzzer' comes on. It will continue for one hour and 59 minutes and then shut itself off
automatically, and reset itself for the following day.
4. To stop the buzzer immediately, press the ALARM / RESET button. The buzzer stops and the alarm resets itself for the following day.
5. To shut the alarm off completely set the alarm ON
/ OFF switch to the ‘OFF’ position.
SNOOZE / REPEAT ALARM
If you need a few extra minutes sleep after the buzzer comes on, press the SNOOZE button. The buzzer stops for approximately 9
minutes and then it starts again. The Snooze operation can be repeated several times if necessary.
CARE AND MAINTENANCE
If the cabinet becomes dusty wipe it with a soft dry cloth. If it becomes dirty or smudged with fingerprints you may use a slightly damp
cloth, but never allow water or any other liquid to get inside the cabinet.
WARNING :
To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
A TTENTION : To reduce the risk of electric shock,
do not remove the cover. There are no user
serviceable parts inside the unit. Refer all
servicing to qualified personnel.
IMPORTANT NOTES
The lightening flash with arrowhead symbol within the
triangle is a warning sign alerting the user of "dangerous
voltage" inside the unit.
The exclamation point within the triangle is a warning
sign alerting the user of important instructions
accompanying the product.
Emerson Radio Corp. warrants manufacturing defects in original material,
including original parts and workmanship, under normal use and
conditions, for a period of ninety (90) days from the date of original
purchase in the U.S. With your dated proof of purchase, we will provide
repair service at no charge for labor and parts at an authorized Depot
Repair Facility, or replace the product in our discretion. For repair or
replacement, pack your unit in a padded box, enclose your check or money
order payable to Emerson Radio Corp. in the amount of $5.00 (not required
by California residents) to cover shipping and handling costs, and enclose
a copy of your proof of purchase. Send your unit to:
Emerson Radio Corp.
1901 Diplomat Drive,
Farmers Branch, TX 75234.
This warranty does not cover da mage from negligence, misuse, abuse, a ccident,
failure to follow operating instructions, commercial use, rental, repairs by a n
unauthorized facility , or products purchased, used, serviced or da maged outside
of the United States.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND
YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM
STATE TO STATE.
AU898H
LIMITED WARRANTY
Loading...