Emerson CKS2237 User Manual
Jumbo Display
Dual Alarm AM/FM Clock Radio
®
with SmartSet
Auto Time Setting System
and Sure Alarm
(U.S. Patent No. 6,567,344)
OWNER’S MANUAL
CKS2237
Visit our web site at www.emersonradio.com
CKS2237_073106.p65 31/7/2006, 11:3422
!
CAUTION
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to
alert the user to the presence
of uninsulated ‘dangerous voltage’
within the product’s enclosure
that may be of sufficient
magnitude to constitute a risk
of electric shock to persons.
WARNING: TO REDUCE THE
RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER
(OR BACK), NO U SER
SERVICEABLE PARTS INSIDE
REFER SERVICING TO
Q U A LI F IE D S E R VI C E
PERSONNEL.
The exclamation point within
an equilateral triangle is intended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in
the literature accompanying the appliance.
The Caution Marking maybe located at the bottom enclosure of the apparatus.
IMPORTANT SAFETY INSTRUCTIONS
1.) Read these instructions. Keep these instructions. Follow all instructions. Heed all warnings.
2.) Do not use this apparatus near water.
3.) Clean only with dry cloth.
4.) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
5.) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
6.) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
7.) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
8.) Only use attachments / accessories specified by the manufacturer.
9.) Unplug this apparatus during lightning storms or when unused for long periods of time.
10.) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
11.) This appliance shall not be exposed to dripping or splashing water and no object filled with liquids
such as vases shall be placed on the apparatus.
12.) Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13.) Do not overload wall outlet. Use only power source as indicated.
14.) Use replacement parts as specified by the manufacturer.
15.) The product may be mounted to a wall only if recommended by the manufacturer.
16.) Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks.
1
CKS2237_073106.p65 31/7/2006, 11:111
Congratulations!
And thank you for purchasing the Jumbo Display SmartSet
®
Clock Radio from
Emerson Research. SmartSet® is the world’s first and only LED clock radio that
will automatically set itself to the correct ‘Year’, ‘Month’, ‘Date’, ‘Day’, and ‘Time’ as
soon as you plug it in. The only thing you have to do is tell the SmartSet® what time
zone you are in, and the built in computer does everything else for you immediately.
And not only the first time, but every time the power is interrupted as well.
We all know how annoying it is to wake up in the morning and see the dreaded
flashing “12:00” display on our clock s or clock radios. But with your SmartSet
Clock Radio the dreaded flashing “12:00” display is a thing of the past.
The SmartSet® resets itself as soon as the power is restored and gets you up on
time, every time.
And if that isn’t enough, the SmartSet® computer also knows when Daylight Saving
Time begins and ends and it will adjust itself for those changes automatically through
the year 2099! Leap Years too! And best of all, the long life lithium battery backup
battery is already installed in your radio. You don’t have to remember to put a new
9-volt battery in your radio every 6 months. Under normal circumstances the lithium
battery can last for up to 5 years, and when it does need to be changed, a low
battery indicator will ‘flash’ to let you know. The CR2430 lithium battery is available
almos t anywhere that batteries are sold and it costs about the same as a normal
9-volt battery.
®
The SmartSet® also gives you dual alarms that can be set to go off on weekdays
only, weekends only, or all 7 days. You can set one alarm to wake you up to buzzer
Monday through Friday when you have to get up early, and use the second alarm
to wake you up to soft music on Saturday and Sunday when you can sleep in.
Someday all clocks and clock radios may be this smart. But today the technology
is only available from Emerson Research. We’re sure you’ll be happy and amazed
by your SmartSet® Clock Radio, and that it will give you many years of enjoyment
and dependable service.
Once again, all of us at Emerson Research thank you for your purchase.
2
CKS2237_073106.p65 31/7/2006, 11:112
IMPORTANT NOTES
• Avoid installing this unit in plac es
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters, on top of other stereo
equipment that radiates too much
heat, places lacking ventilation or dusty
areas, places subject to constant
vibration and/or humid or moist areas.
• Operate controls and switches as
described in the manual.
• Before turning on the power, make
certain that the power cord is properly
installed.
• When moving the set, be sure to first
disconnect the AC power cord.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection agains t harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
3
CKS2237_073106.p65 31/7/2006, 11:113
PREPARATION FOR USE
UNPACKING AND SET UP
• Remove the radio from the carton and remove all packing material from the
radio. We suggest that you save the packing material, if possible, in the unlikely
event that your radio ever needs to be returned for service. The original carton
and packing material is the only safe way to pack your radio to protect it from
damage in transit.
• Remove any descriptive labels or stickers on the front or top of the cabinet. Do
not remove any labels or stickers from the back or bottom of the cabinet.
• Note the serial number on the bottom of your radio and write this number in the
space provided on the Warranty page of this manual.
• Place your radio on a level surface such as a table, desk or shelf, convenient to
an AC outlet, out of direct sunlight, and away from sources of excess heat,
dirt, dust, moisture, humidity, or vibration.
NOTE: Do not place this radio on a metal shelf, metal table, or other
metal surface as this may interfere with AM reception.
• Unwind the AC power cord and extend it to its full length. The FM antenna is
built in to this cord. It must be fully extended to provide the best FM reception.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
4
CKS2237_073106.p65 31/7/2006, 11:114
POWER SOURCE
AC Outlet
This radio is designed to operate on normal 120V 60Hz AC power only. Do not
attempt to operate the radio on any other power source. You could cause damage
to the radio that is not covered by your warranty.
This radio should be connected to an AC outlet that is always ‘live’. Do not connect
it to an outlet that is controlled by a wall s witch. When the power to the radio is
interrupted, the built in lithium battery takes over to maintain the time and alarm
settings. To maximize the life of the lithium battery keep the radio connected to a
‘live’ AC outlet at all times
You will note that this system is equipped with a polarized AC power plug having
one blade wider than the other. This is a safety feature.
If this plug does not fit into your existing AC
outlet, do not try to defeat this safety feature by
filing the wide blade to make it fit into your outlet.
If this plug will not fit into your outlet, you
probably have an out-dated non-polarized AC
outlet. You should have your outlet changed by
a qualified licensed electrician.
AC Plug
SURE ALARM BATTERY BACK-UP SYSTEM
This SmartSet® Clock Radio includes a Sure Alarm battery back-up circuit that can
wake you up even if the power is ‘Off’ at the selected wake up time. If your power
is ‘Off’ at the selected wake up time the clock display will be off and the radio will
not operate, but a separate mini-buzzer will turn ‘On’ automatically to wake you up,
even if you had selected the “Wake to Radio” option. The Sure Alarm will sound for
30 seconds and then shut off automatically.
To s top the Sure Alarm buzzer immediately, press the RADIO ON/OFF button.
Pressing the SNOOZE button has no effect during Sure Alarm operation.
NOTE: In order to maximize the life of the built in lithium battery, pleas e be
sure to set the ALARM 1 and ALARM 2 switches to the “OFF” position if the
radio will be disconnected from the AC outlet for more than a few hours. This
will prevent the Sure Alarm from turning ‘On’ unecessarily.
5
CKS2237_073106.p65 31/7/2006, 11:115
LOCATION OF CONTROLS AND INDICATORS
7
21
12
13
14
27
2
1
18
19
3 4 5 6
20
Top Panel
1.) MONTH/DATE Setting Button.
2.) TIME setting Button.
3.) ALARM MODE Button.
(weekdays/weekends/everyday alarm)
4.) ALM(Alarm) 1 Setting Button.
5.) ALM(Alarm) 2 Setting Button.
6.) SNOOZE/SLEEP OFF Button.
7.) SET – Button.
8.) SET + Button.
9.) TIME ZONE Button.
10.) SLEEP Button.
11.) RADIO ON/OFF Button.
Left Side
12.) ALARM 1 Selector Switch.
(RADIO/BUZZER/OFF)
13.) ALARM 2 Selector Switch.
(RADIO/BUZZER/OFF)
14.) Display DIMMER(HIGH/LOW) Switch.
9
8
22
10
23
11
26
24
15
16
17
25
Right Side
15.) VOLUME Control.
16.) BAND(AM/FM) Switch.
17.) TUNING Control.
Front Panel
18.) ALM(Alarm) 2 ‘On’ Indicator.
19.) ALM(Alarm) 1 ‘On’ Indicator.
20.) AM Indicator.
21.) Time Display.
22.) Day Indicators.
23.) BATT. LOW Indicator.
24.) Month/Date Display.
25.) Lighted Dial Pointer.
Back Panel
26.) Back Up Battery compartment.
(Back Cabinet)
27.) AC Power Cord.
CKS2237_073106.p65 31/7/2006, 11:116
6
Loading...