Emerson CKD9907 User Manual

COMPACT DISC PLAYER
with STEREO CLOCK RADIO
OWNERS MANUAL
CKD9907
Visit our web site at www.emersonradio.com
CKD9907_ib.p65 2001/4/17, PM 12:1916
Thank You..........
The serial number of your unit can be found on the bottom of the cabinet. We suggest that you record the serial number in the space provided below in case this information is ever needed at a future date.
Model Number: CKD9907 Serial Number: ________________________________
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT
APPAREIL Á LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
This product contains a low power Laser Device.
DANGEROUS VOLTAGE Uninsulated Dangerous Voltage, that may be of sufficient magnitude to constitute a risk of electric shock to persons is present within this product's enclosure.
ATTENTION The Owner's Manual contains important operating and maintenance instructions. For your safety, it is necessary to refer to the manual.
CKD9907_ib.p65 2001/4/17, PM 12:191
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS
DEFEATED.
AVOID EXPOSURE TO BEAM
1
IMPORTANT NOTES
Avoid installing the unit in locations described below :
 Places exposed to direct sunlight or
close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas.
 Do not attempt to clean this unit with
chemical solvents as this might damage the finish. Use a clean dry cloth.
 Operate controls and switches as
described in the manual.
 Store your CDs in a cool area to
avoid damage from heat.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation.
2
CKD9907_ib.p65 2001/4/17, PM 12:192
PREPARATION FOR USE
UNPACKING AND SET UP
Remove the unit from the carton and remove all packing material from the unit.
Remove any descriptive labels or stickers from the top or front of the cabinet.
Do not remove any labels or stickers from the back or bottom of the cabinet.
Press the CD Open button to open the CD door. Remove the white transit card
from the CD compartment, if applicable. This card is used to prevent the laser pick up from moving during shipment. It must be removed from the CD compartment before you insert a disc.
Remove the twist tie from the AC power cord and extend the cord to its full
length.
Unwind the lead wire FM antenna and extend it to its full length.
Place the radio on a level surface such as a stand, desk, table or shelf, convenient
to an AC outlet, and away from direct sunlight or sources of excess heat, humidity, moisture, dust or vibration.
BATTERY BACK UP SYSTEM
This clock radio has a battery back up system that will maintain the time and alarm settings in the event of a temporary power interruption. The system requires one 9-volt battery, not included.
Open the battery door on the bottom of the cabinet and connect a 9-volt battery to the battery terminals inside the compartment. It can only be connected one way. Push the battery into the battery compartment and replace the battery door.
If the power is interrupted the clock display goes off and the unit will not operate. However the battery will maintain the time and alarm settings, and when the power is restored the time and alarm settings will be correct.
3
CKD9907_ib.p65 2001/4/17, PM 12:193
POWER FAILURE INDICATION
If the battery is exhausted, or there is no battery installed and the power is interrupted, the time and alarm settings will be lost. When power is restored the clock display will return to its default setting 12:00 and begin counting forward from that point. If you notice that the time on the display is incorrect, check your alarm settings as well. If they are also incorrect this indicates that the power was interrupted and the battery is exhausted. Replace the battery with a new one and reset both the time and alarm settings.
POWER SOURCE
This radio is designed to operate on 120V 60Hz AC house current only. Attempting to operate this radio from any other power source may cause damage to the unit, and such damage is not covered by your warranty. Be sure that the AC outlet you use is always live. Do not connect this unit to an outlet that is controlled by a wall switch.
This unit has a polarized AC plug with one wide blade and one narrow blade. This plug will only fit into a matching polarized AC outlet. This is a safety feature to reduce the possibility of electric shock. If this plug will not fit in your AC outlet, you probably have an outdated non-polarized outlet. You should have your outdated outlet changed by a qualified, licensed electrician. Do not file the wide blade on the plug, or use an adapter to make the plug fit into your outlet. This defeats the safety feature and could expose you to electric shock.
CKD9907_ib.p65 2001/4/17, PM 12:194
4
LOCATION OF CONTROLS

'
&
%
$
#
"
!
$
#
"

!
#
%
'
%
&
"
"
$ &
!
! ! ! '
1. POWER On/Off Button.
2. Power On Indicator.
3. SLEEP Button.
4. VOLUME Control.
5. DISPLAY Mode Button.
6. RANDOM Button.
7. ALARM (SET/ON/OFF) Switch.
8. CLOCK Adjust Button.
9. CD Door.
10. AC Power Cord.
11. FM Wire Antenna.
12. Battery Compartment (at bottom cabinet).
13. FUNCTION (CD/AM/FM/BUZZER) Switch.
14. CD PROG (Program) Button.
15. CD REPEAT Button.
16. CD SKIP + / HOUR Button.
CKD9907_ib.p65 2001/4/17, PM 12:195
17. TUNING Control.
18. CD SKIP  / MINUTE Button.
19. CD PLAY/PAUSE
20. CD Door OPEN
Button.
Button.
21. SNOOZE Button.
22. CD STOP
Button.
23. Tuning Dial.
24. Speakers.
25. ALARM On Indicator.
26. AM Indicator.
27. LED Display.
28. FM STEREO Indicator.
29. CD RANDOM On Indicator.
30. SLEEP On Indicator.
31. CD REPEAT On Indicator.
32. CD PROG (Program) On Indicator.
5
Loading...
+ 11 hidden pages