5) To turn right, push the left joystick knob forward,
right joystick knob backward.
6) To turn left, push the left joystick knob to backward,
right joystick knob forward.
Ranger Remote Control
Metal Detector
Right
Turn
7) To optimize your search, follow the pattern below.
Make sure that you stay within the 25-foot range.
8) When the Metal Detector nds a buried metal object,
it will beep and the LED light will ash.
Left
Turn
INSTRUCTION MANUAL
“ This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation”.
7
P38-EL129-81001001
WARNING!
Operation:
- Do not expose your Metal Detector to rain or moisture.
- Do not play in a crowded environment.
- Do not play in a dusty area.
- Use only your Metal Detector transmitter included in this package.
- This toy is not intended for children under 3 years old.
- This instruction manual contains important information; please keep it.
- Always turn your RC Metal Detector o when not in use.
- Do not use it close to swimming pools, clis, lakes, riverbanks, etc.
- Do not use in environments such as low-visibility areas, bushes, and swamps.
- Always ask permission before venturing onto private property.
Battery Disposal
- Do not dispose of the battery in your regular household waste.
- Contact your local waste management ocials for information on
1) Slide the on/o switch to the On position.
- Place the Metal Detector on the surface to be searched.
- Do not operate the vehicle in soft sand, water, or tall grass as it
may damage the vehicle.
2) To move the vehicle forward, push both joystick knobs forward.
3) To stop, release both joystick knobs to the original position.
environmentally sound disposal of rechargeable batteries.
- If a battery leak develops, avoid contact with leaking uid. Place the
damaged battery in a plastic bag for proper disposal.
- If uid comes into contact with skin or eyes, wash with cool water for at
least 15 minutes.
- Dispose of batteries safely, following guidelines for your area.
1
4) To back up, pull both joystick knobs backward.
Backward
Forward
6
Assembly:
Battery Safety Guidelines
For Transmitter:
- To prevent battery leakage, be sure to insert batteries correctly.
Sensitivity Calibration:
Antenna
Red LED
- Batteries should be replaced by adult.
- Never dispose of batteries in re as this may cause them to explode.
- Do not mix old and new batteries (replace all batteries at the same time).
- Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries (or equivalent). Only use batteries of the
same or equivalent type as recommended.
- Nonrechargeable batteries are not to be recharged.
- Always remove exhausted or dead batteries from product. Remove
batteries from product when it will not be used for a long time.
Otherwise the batteries may leak and cause damage.
- Do not short-circuit supply terminals.
- Make sure battery compartment is secure.
- Do not immerse battery-operated toys. Wipe clean only.
1) Adjust the ne-tune knob counterclockwise, until long beep
tone is heard and red LED is on.
2) Then turn the knob backward slowly until the beep tone is JUST
OFF and red LED is o. At this moment, the Metal Detector is
at its most sensitive.
25
Contents:
Battery Installation:
Antenna
Joystick Knobs
Transmitter
Antenna
Requires 9 volt battery and 4 "AA" batteries 1.5 volts (not included)
For Transmitter:
CLOSE
1) Open or close the cover with
a Phillips head screwdriver.
OPEN
2) Insert one 9V (6LR61)
alkaline battery.
For Metal Detector:
CLOSE OPEN
Red LED
RC Metal Detector
3
1) Open or close the cover with
a Phillips head screwdriver.
2) Insert four AA (LR6)
1.5V batteries.
4
Loading...