Electrolux ELM 5250, EMS5010 User Manual
ELM 5250
.
EMS5010
EN
2
Components
A. ON/OFF button
B. Espresso button
C. Espresso lungo button
D. Lever
E. Capsule compartment
F. Water tank
G. Steam / hot water knob
H. Steam / hot water spout
I. Steam button
J. Coee spout
K. Cup support rack
L. Drip tray
M. Waste water indicator
N. Used capsules container
O. Power cord & plug
EN
A
B
C
D
E
F
G
H
I
J
K
M
N
O
L
No
EN
Espresso Machine ELM5250
3
Safety advice
Read the following instruction carefully before using the machine for the
first time.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to
ensure that they do not play with the
appliance.
• The appliance may only be connected
to a power supply whose voltage
and frequency comply with the
specifications on the rating plate!
• Never use or pick up the appliance if
– the supply cord is damaged,
– the housing is damaged.
• The appliance must only be connected
to an earthed socket. If necessary an
extension cable suitable for 10 A can
be used.
• If the appliance or the supply cord
is damaged, it must be replaced by
the manufacturer, its service agent or
similarly qualified person, in order to
avoid hazard.
• Always place the appliance on a flat,
level surface.
• Never leave the appliance unattended
while connected to the supply mains.
• The appliance and accessories
become hot during operation. Use
only designated handles and knobs.
Allow to cool down before cleaning or
storage.
•
The mains cable must not come into
contact with any hot parts of the
appliance.
• When the steam function is used there
can be some hot water dripping from
the brewing head. DANGER! The water
is hot, there is a risk for scalding.
• When opening the steam valve there
is a shot of hot water coming out.
Be careful and open the steam valve
slowly. DANGER! The water is hot,
there is a risk for scalding.
• Do not immerse the appliance in
water or any other liquid.
• Do not exceed the maximum
volume as indicated on the appliances.
• Fill the water tank only with cold
water, never with milk or other liquids.
• Do not use the appliance if the water
tank has not been filled.
• Do not use the appliance without the
drip tray or the drip grid.
• This appliance is intended for domestic use only. The manufacturer cannot
accept any liability for possible damage caused by improper or incorrect
use.
• Do not carry machine by the handle.
• This machine can only be used with
Lavazza A MODO MIO capsules. Do not
put your fingers or any other object
in the capsule compartment. The capsules can be used only once.
• If the steam function is used continuously over 1 hour time period, there
must be a pause of 2 min after each
steam use, otherwise the lever can
become hot.
• Never switch on the machine with
steam/hot water knob in steam position.
EN
EN
!
Getting started
1. Place the machine on a flat surface
and fill the tank with cold, drinkable
and non sparkling water. (The machine
must not be used with empty tank!)
Plug the power cord into the mains
and press the ON button. The machine
is ready to use when the cup indicator
lights stop flashing and become
steady.
2. When starting the machine for the
first time: Place a bowl under the
steam/hot water pipe and turn the
knob to the steam/hot water position.
Run ½ of the container and turn the
knob back.
3. The machine must not be used with
empty tank! If you use it without
water for a too long time the auto
priming could be blocked. To prime
the circuit, place a bowl under the
hot water pipe and turn the knob to
the steam/hot water position. When a
steady flow comes out from the pipe,
turn the knob back.
4
30 min Auto-off
Preparing coee
EN
1. Adjust the coee spout height for
dierent cup sizes by either pulling it
down or pushing it up.
The machine is equipped with
an energy saving function that
automatically switches it o after
30 min of inactivity.
4. Lift the lever, insert a capsule in
the compartment. Close the lever
and press either Espresso or Espresso
lungo button. The machine will stop
automatically . When the coee is
ready, lift the lever and the capsule
falls down into the used capsules
container.
2. Light. The machine is equipped with a
lamp which lights up the cup support
rack. The light will be on during the
brewing time and will switch o a few
seconds after the cup is ready.
5. Programming coee amount. Place
a cup on the cup support rack. Press
and hold the espresso or espresso
lungo button. Release when desired
coee amount is reached. The
programmed quantity is memorized
by the machine.
3. A MODO MIO capsules. Only suitable
Lavazza “A MODO MIO” capsules
should be placed in the capsule
compartment. Single dose capsules
brew a single coee.
DO NOT use the capsules more than
once. Inserting 2 or more capsules can
cause the machine to malfunction.
5
EN
Using hot water/Steam functions
1. Hot water function. Place a cup under
the steam spout. Turn the knob to
steam/hot water position, and turn it
back to stop.
Preparing coee after steam
2. Steam can be used to froth milk
or to heat liquids. Press the steam
button. The light is flashing. When
steady, the machine is ready. Place
an empty container under the spout.
Turn knob to steam position for a few
seconds to purge residual water. Then
close the knob.
3. Fill 1/3 of a container with cold milk.
Immerse the steam spout into the milk
and turn the knob. Froth the milk by
swirling the container. When ready
turn the knob back. Caution: the
steam pipe is hot! Always use the
plastic handle when touching the
steam spout.
1. Preparing coee after steam. To
prepare coee, insert a capsule, close
the lever and press either the Espresso
or the Espresso lungo button (there is
a short cooling cycle before the coee
comes out).
Loading...