Electrolux EI30EF55GBA, EI30EF55GSA, EI30EF55GSB, EI30EF55GWA, EW30EF65GBA Installation Guide
...
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i__¸
Installation Instructions
Instrucciones de Instalacion
Es_uff_ Eh_s:t._ic_ _ 30"
Electrolux
INSTALLATION AND SERVICE MUST BE PERFORMED BYA QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1. Provide adeauate clearances between the range and adjacent combustible surfaces.
2. Location--Check location where the ranqe will be installed. Check for proper electrical supply, and the stability of the floor.
3. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid
and level.
RANGE
OVERALL
RANGEELECTRICAL
CONNECTIONS
FRONT-- TYPICALCABINETINSTALLATION_ SIDE
VIEW
DIMENSIONS
ii dimensionsfoi
......... 3o"--.j,,..._
25-3/4"
4 /2"
•5/8"** 29-7/8" "'_ -_>
Door Open \_,""_" -- - -
WW
Fig, 1 Depthis28-13/32"withdoorhandle.
*30" MINIMUM CLEARANCE BETWEEN THE TOP OFTHE COOKING SURFACEAND THE BOTTOM OFAN UNPROTECTED WOOD OR METAL
CABINET; OR 24" MINIMUM WHEN BOTTOM OF WOOD OR M ETAL CABINET IS PROTECTED BY NOT LESS THAN 1/4" FLAME RETARDANT
MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015" STAINLESS STEEL, 0.024" ALUMINUM OR 0.020" COPPER.
0" CLEARANCE IS THE MINIMUM FOR THE REAR OF THE RANGE. FOLLOW ALL DIMENSION REQUIREMENTS PROVIDED ABOVE TO
PREVENT PROPERTY DAMAGE, POTENTIAL FIRE HAZARD, AND INCORRECT COU NTERTOP AND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE LOCATED
ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN BE REDUCED BY
INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" BEYOND THE BOTTOM OF THE CABINETS.
I_ _Dashedcubedarea 1
_Center,ine showswherethe |
I ofrange electrical outlet must /
II I beinstalledforflush to/
I -_-111",,,thewallinstallati°n. J
2-5/8"for modelsequipped
withwarmerdrawers,
3-1/2"for modelsequipped
withstorage drawers Fig. 2
lectricaloutlet locationI
remaximum, j
_30" --_
Minimum
Minimumto 1"4_
walloneither
sideofrange
above36"height.
Fig. 3 <_ 30"
®'® _ ®'®
_F 1 t eithersideMinimumt°
30"
'k
1_-13"-_
18" cabinetson
_ ofrange.
O"clearancebelow cookingtop andat rearofrange.
Maximumdepth
for cabinets
aboverangetop.
IMPORTANT SAFETY INSTRUCTIONS
• ALL RANGES
CAN TIP
• INJURY TO PERSONS
COULD RESULT
• INSTALL ANTI-TIP
DEVICE PACKED WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
_'!_lviV-'1_t#ll_[_llIf the information in this manual is not followed
exactly, a fire or electrical shock may result causing property
damage, personal injury or death.
Important Notes to the Installer
• Read all instructions contained inthese installation instructions
before installing range.
• Remove all packing material from the oven compartments
before connecting the gas & electrical supply to the range.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructionswith yourowner's guide forfuture reference.
As when using any appliance generating heat, there are
certain safety precautions you should follow. These are listed
in the Use & Care Guide, read it carefully.
Be sure your range is installed and grounded properly by a
qualified installer or service technician.
Make sure the wall coverings around the range can withstand
the heat generated by the range.
To eliminate the need to reach over the surface elements,
cabinet storage space above the elements should beavoided.
Serial Plate Locations:
Serial plate Iocatio
Serial plate is located on the lower right front frame of the appliance.
Alternate location may be under cooktop.
EspaiSol - P&ginas 5-8
Loading...