Built-In Dishwasher Specifications
•
Product Weight – 93 Lbs.
•
Voltage Rating @120V /60 Hz/ 15 Amps
•
Connected Load (kW Rating) @120 Volts = 1.44kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded for
safe operation.)
•
Amps @120V = 9 Amps
•
Always consult local and/or national electric & plumbing codes.
•
Water Pressure – Hot water line to dishwasher must provide between
15 and 120 pounds per square inch (psi).
•
Make sure location has right drain, water and electrical outlets to make
connections.
•
Keep back free of drain, water & electrical supply.
•
Electrical and water supplies should enter cabinet opening on floor, or
through back or side walls, as shown in shaded areas.
•
Connections preferably located toward left side of dishwasher. Do not
cross drain, water or electrical lines in front of motor, blower or frame.
•
Minimum clearance of 5/16" required from unit to underside of countertop.
•
Leveling legs supplied to adjust height. (Note: Height only adjustable to
34-11/16" max. when installed in 35" max. standard cabinetry cutout to
allow for 5/16" min. clearance.)
•
When installing adjacent to wall, cabinet or other obstruction that extends
beyond front edge of unit, allow 2" minimum clearance between opened
door and obstruction.
•
When installing at end of cabinet line, sides must be fully enclosed.
•
Do not install unit under a cooktop, damage may occur.
•
Dishwasher designed to also accept custom door panel to match with
custom cabinetry. (Refer to Custom Panel Specifications on this page.)
Custom Panel Specifications
•
Panel Dimensions – 30-1/8"H max. x 23-11/16"W x 3/4" D
•
Panel Weight – 12 Lbs. max (including handle)
•
Refer to web for detailed custom panel construction and installation
instructions.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
Built-In Dishwasher
EDW7505HPS professional series
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA
•
250 Bobby Jones Expressway •Augusta, GA 30907 •1-877-4electrolux (1-877-435-3287)
•
electroluxicon.com
CANADA
•
5855 Terry Fox Way •Mississauga, ON L5V 3E4 •1-800-265-8352
•
electroluxicon.ca
EDW7505HPS 12/08 © 2008 Electrolux Home Products, Inc. Printed in the U.S.A.
Water inlet and power supply
location (middle bottom rear)
497/8"
22
1
/2"
Right
Door in 90°
open position
273/8"
Custom Panel
Specifications
301/8"
max.
2311/16"
Thickness: 3/4"
Weight: 12 lbs. max.
(including handle)
1315/32"
23"
13
/32"
235/32"
239/32"
235/32"
9
/16"
13
/32"
2 Pilot drill holes*
(
1
/8"dia. x 1/4"max.depth)
6 Pilot drill holes
(
1
/8"dia. x 3/8"max.depth)
*Optional holes for adding 1/2"- #7 screws
which slip into rectangular openings of
metal panel to help locate custom door
panel for other outside screw attachment
Refer to web for detailed door panel
construction and installation instructions.
Note: All handle
attachment
screws must be
flush/recessed
below panel
surface.
14
17
/32"
13
/32"
17
/32"
31/2"min.to
41/2"max.
1
3
/4"
1
3
/4"1
3
/4"
**NOTE:
35"max. height for
standard cabinetry cutout.
(5/16"min. clearance
required from unit to
underside of countertop.)
3"
18"
24"
min.
Electrical, water,
and drain lines
must be confined
to shaded area
13/4"
24"
3
"
90
°
90
°
Preferred
drain areas
3
"
34"
min.
to
35"
max.**
Front
*Height only adjustable to 3411/16"max. when
installed in 35"max. standard cabinetry cutout
337/8"
Adjustable
to 34
7
/8"*
233/4"
Dishwasher
designed to also
accept custom
door panel.
(Refer to
Custom Panel
Specifications
below.)
Left
245/8"