EKWB EK-UNI Holder DDC Spider 140mm FAN Service Manual

Revision 1.0. Released on 6th of September, 2015.

Installation and mounting manual for EK-UNI Holder DDC Spider

140mm FAN

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before
installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

1. Please carefully read the manual before beginning with the installation process!

2. The EK-HFB and EK-ACF type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.

3. The use of corrosion inhibiting coolants is always recommended for any liquid cooling system. EKWB recommends any of the EK-Ekoolants for worry-free usage.

STEP 1 INSTALLING THE ASSEMBLY USING CUSTOM HOLDER EK-UNI Holder DDC Spider 140mm FAN

If you have an option to mount the assembly on 140mm fan or 140mm FAN mounting holes, EKWB
recommends simple and elegant solution -

EK-UNI Holder DDC Spider 140mm FAN

.

REQUIRED TOOLS: Allen key 2,5mm (enclosed)

Screw for mounting the Spider Holder on the
140mm FAN mounting holes:

Option 1: use self-tapping screws normally supplied

with fan to screw the holder directly on the fan
Option 2: use 30mm long screw supplied with
radiator delivery to screw the holder on the
radiator through the 140mm fan.
Option 3: use 5mm long screw normally supplied
with radiator delivery to screw the holder directly
on the radiator
Option 4: use M4 × 6mm screw with M4 nuts and
washers (supplied with the Spider Holder delivery)
and mount the holder on the 140mm FAN
mounting holes on the chassis.

140mm FAN

EK-XRES 100 DDC MX assembly

M4 × 4mm DIN7984 screw

+ M4 PVC washer