Loading...
EK-Velocity sTR4
CPU WATER BLOCK
1st Revision, January 28th 2019 |
USER GUIDE |
|
|
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
Please carefully read the manual before beginning with the installation process!
Please remove your graphics card from the computer to assure safest mounting process in order to prevent any possible damages to your GPU and/or graphics card circuit board (PCB).
The EK Fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber
O-ring gaskets.
The use of corrosion inhibiting coolants is always recommended for liquid cooling systems, and mandatory for nickel plated water blocks!
Do not use pure distilled water! For best results EK recommends the use of EK-CryoFuel coolants!
Make sure to thoroughly bleed air out of your water block, or you will not reach optimal performance!
TABLE OF CONTENT
GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY |
4 |
SUPPORT AND SERVICE |
9 |
WHAT IS ENCLOSED |
5 |
SOCIAL MEDIA |
9 |
QUICK INSTALLATION GUIDE |
|
|
|
INSTALLING THE WATER BLOCK |
5 |
|
|
CONNECTING THE RGB LED STRIP (for full nickel version) |
7 |
|
|
CONNECTING THE RGB LED STRIP |
7 |
|
|
CONNECTING THE D-RGB MODELS |
8 |
|
|
CONNECTING THE D-RGB LED STRIP |
8 |
|
|
- 3 -
Loading...