EKWB EK-Supremacy Classic RGB User Manual

EK-Supremacy Classic RGB

CPU WATER BLOCK

1st Revision, October 27th 2018

USER GUIDE

This product is intended for installation only by expert users. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes no
liability whatsoever, expressed or implied, for the use of these products,
nor their installation. The following instructions are subject to change
without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read important notice, disclosure
and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

Please carefully read the manual before beginning with the
installation process!

Please remove your graphics card from the computer to assure
safest mounting process in order to prevent any possible damages
to your GPU and/or graphics card circuit board (PCB).

The EK Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the rubber
O-ring gaskets.

The use of corrosion inhibiting coolants is always recommended
for liquid cooling systems, and mandatory for nickel plated
water blocks!

Do not use pure distilled water! For best results EK recommends the
use of EK-CryoFuel coolants!

Make sure to thoroughly bleed air out of your water block, or you will
not reach optimal performance!

TABLE OF CONTENT

GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY 4
WHAT IS ENCLOSED 4

QUICK INSTALLATION GUIDE

INSTALLING THE WATER BLOCK 5

LGA20XX SOCKET MOTHERBOARDS 5
LGA115X SOCKET MOTHERBOARDS 7
AMX AND FMX SOCKET MOTHERBOARDS 8

CONNECTING THE RGB LED STRIP 10

CONNECTING THE RGB LED STRIP 10

SUPPORT AND SERVICE 11
SOCIAL MEDIA 11

- 3 -

GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY

This CPU Liquid cooling units are supporting the following CPU sockets:

a) EK-Supremacy Classic RGB - Nickel + Plexi:

- Intel® Socket LGA-115x

- Intel® Socket LGA-20XX

b) EK-Supremacy Classic RGB - AMD Nickel + Plexi:

- AMD® AMx

- AMD® FMx

a) EK-Supremacy Classic

RGB - Nickel + Plexi

b) EK-Supremacy Classic

RGB - AMD Nickel + Plexi

WHAT IS ENCLOSED

a) EK-CPU Classic RGB – Nickel + Plexi CPU water block:

- EK-CPU Supremacy Classic RGB – Nickel + Plexi CPU
water block.

- CPU mounting mechanism:

• M3 threaded thumb screws (4 pcs)

• LGA-20XX M3 threaded mounting studs (4 pcs)

• Springs (4 pcs)

• M3 threaded thumb nuts (4 pcs)

• Washers (4 pcs)

- EK- CPU Supremacy Classic RGB – Nickel + Plexi Backplate:

• Backplate rubber gasket

• Backplate for Intel® LGA-115x socket motherboards

- Thermal grease

b) EK-Supremacy Classic RGB - AMD Nickel + Plexi water block:

- EK-CPU Supremacy Classic RGB – Nickel + Plexi CPU
water block.

- CPU mounting mechanism:

• M3 threaded thumb screws (4 pcs)

• Plastic standoffs

• Springs (4 pcs)

• M3 threaded thumb nuts (4 pcs)

- Thermal grease

- 4 -