EKWB EK-Quantum Vector RTX 3080 D-RGB, EK-Quantum Vector RTX 3090 D-RGB Installation manual

EK-Quantum
Vector RTX 3080/3090 D-RGB

GPU WATER BLOCK

USER GUIDE

Before you s tart using this prod uct, please follow t hese basic guidelines:

Carefully read the manual before beginning with the
installation process.

Remove your graphics card from the computer for the safest
mounting process, to prevent any possible damage to your
GPU or its circuit board (PCB).

EK Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured with the
rubber O-ring gaskets.

The use of quality market-proven corrosion-inhibiting
coolants is always strongly recommended for any liquid
cooling system.

Do not use pure distilled water as a cooling liquid! For best
results, EK recommends the use of EK-CryoFuel Coolants.

Make sure to bleed air out of your water block thoroughly in
order to reach optimal performance.

TABLE OF CONTENTS

BOX CONTENTS 4
WATER BLOCK DIMENSIONS 5
PREPARING THE GRAPHICS CARD 6

REMOVING THE S TOCK COOLER 6
CLEANING THE PCB 6
CUT TING AND PLACING THERMAL PADS 7
APPLYING THERMAL COMPOUND 8

INSTALLING THE WATER BLOCK 8

PLACING THE BLOCK ON THE GRAPHICS CARD 8
ATTACHING THE BLOCK TO THE GRAPHICS CARD 9
CHECKING FOR CONTACT 9
INSERTING THE GR APHIC S CARD INTO THE CHASSIS 9

INSTALLATION OF FITTINGS AND TUBING 10
CONNECTING THE D-RGB LED STRIP* 10
TESTING THE LOOP 11
SUPPORT AND SERVICE 12
SOCIAL MEDIA 12

- 3 -

BOX CONTENTS

4 mm

6 mm

Mounting mechanism - You may not need all the screws, mounting mechanism is universal!

M2,5x4 AX1 Screw (16 pcs)EK-Quantum Vector RTX 3080/3090 D-RGB

8 mm

Thermal Grease (1 pc) M2,5x8 AX1 Screw (2 pcs)

4 mm

M3x4 DIN7985 Screw (2 pcs) EK-Loop Multi Allen Key (1 pc)

EK-Plug G1/4 (2 pcs)

M2.5 Nut (2 pcs)

- 4 -

M2,5x6 AX1 Screw (13 pcs)

M2.5 PVC Washers (16 pcs)

Allen Key 2.5. mm (1 pc)

120 mm

16 mm

Thermal Pad F 1.0 mm (4 pcs)