EKWB EK-Quantum Vector D-RGB Upgrade Kit Installation manual

EKQuantum Vector D-RGB Upgrade Kit
INSTALLATION MANUAL
This product is intended for installation by exper t users only. Please consult with a qualified technician. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability whatsoever, expressed or implied, for the use of these products or their installation. The following instructions are subject to change without notice. Please, read the manual carefully before beginning with the installation process.
- 2 -
TABLE OF CONTENT
DISCONNECT THE LEDs 4 REPLACE THE STICKOUT 4 ATTACHING THE NEW STICKOUT AND D-RGB LED 5
PLEXI VERSION 5 ACETAL VERSION 5
ATTACHING THE D-RGB TERMINAL COVER 6 IMPORTANT INFORMATION 6 CONNECTING THE D-RGB LED STRIP 7 SUPPORT AND SERVICE 8 SOCIAL MEDIA 8
- 3 -

DISCONNECT THE LEDs

First , disconnect the cable between the Terminal Cover and Stickou t. After that, remove the Terminal Cover from the FC Terminal.

REPLACE THE STICKOUT

Stickout Screws
Stickout
Remove the Stickout from the water block and store the screws for later use.
If you have the Acetal version of the water block, do not forget to remove the RGB LED from the Acetal part.
- 4 -

ATTACHING THE NEW STICKOUT AND D-RGB LED

Stickout
D-RGB LED
D-RGB LED
Stickout

PLEXI VERSION

Take the Stickout and D-RGB LED from the box.
Remove the protective foil from D-RGB LED and attach the LED to the Stickout.
After this, use the stored screws to secure the Stickout to the Plexi part.

ACETAL VERSION

Take the Stickout and D-RGB LED from the box.
Remove the protective foil from D-RGB LED and attach the LED to the Acetal. D-RGB is oriented towards the Stickout.
After this, use the stored screws to secure the Stickout to the Acetal par t.
- 5 -

ATTACHING THE D-RGB TERMINAL COVER

Take the pre-assembled D-RGB Terminal Cover from the box and attach it to the FC Terminal.

IMPORTANT INFORMATION

Do not forget to connect the D-RGB LED cable of the Stickout to the cable of the Terminal Cover.
In case you have 2 (two) Stickouts: First, connect the Stickout cables and then you can connect them to the Terminal Cover cable!
- 6 -

CONNECTING THE D-RGB LED STRIP

D-RGB Header
RGB Header
Plug the 3-pin connector from the water block’s D-RGB LED light in the D-RGB HEADER on the motherboard. The LED will work if the pin layout on the header is as follows: +5V, Digital.
Please ensure that the arrow indicated on the connector is plugged into t he +5V line as indicated on yo ur motherboard. If you connect the LE Diode to the 12V RGB HEADER you can damage the LEDs.
- 7 -

SUPPORT AND SERVICE

For assistance please contact:
http://support.ekwb.com/
EKWB d.o.o. Pod lipami 18 1218 Komenda Slovenia - EU

SOCIAL MEDIA

EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
EKWBofficial
ekwaterblocks
Loading...