Dymo Wireless PnP User Manual

Quick Start Guide

LabelManager

®

Wireless PnP

Copyright

© 2013 Sanford, L.P. All rights reserved.
No part of this document or the software may be reproduced or transmitted in any form or by any
means or translated into another language without the prior written consent of Sanford, L.P.

Trademarks

DYMO, DYMO Label, and LabelManager are registered marks in the US and other countries. All other
trademarks are the property of their respective holders.

Quick Start Guide

This guide describes some of the features of your DYMO® LabelManager®
Wireless PnP label maker. Read the following sections for information about
using your label maker.

 Registering Your Label Maker

 Getting to Know your Label Maker

 Inserting the Battery Pack

 Removing the Battery Pack

 Inserting the Label Cassette

 Connecting the Label Maker to your Computer

 Starting the Built-In Software

 Printing Labels with the Built-In Software

 Checking the Label Maker Status

 Charging the Battery Pack

 Configuring the Label Maker as a Wireless Printer

 Adding the Wireless Printer

For complete information on using your label maker, download the full
LabelManager Wireless PnP User Guide at userguides.dymo.com.

Registering Your Label Maker

Visit www.dymo.com/register to register your label maker online. During the
registration process, you will need the serial number, which is located above the
label cassette inside the label maker. See Figure 1 on page 2.

Register your label maker to receive these benefits:

 Email notification of free software upgrades

 Special offers and new product announcements

1

Getting to Know your Label Maker

Figure 1

Cleaning tool

Label exit
slot

Cutter

Battery
compartment

Label
compartment

Side
cover

Power button/
status light

Serial number

Wireless
status light

USB port

Reset button

Back View

Become familiar with the features shown in the following figure.

2

Inserting the Battery Pack

Figure 2

Press
and pull

The label maker is powered using a rechargeable lithium-ion polymer (LiPo)
battery pack.

Make sure the USB cable is disconnected before handling the LiPo

battery pack.

To insert the battery pack

1 Press and pull to open the

side cover of the label maker.

2 Insert the battery pack into the

battery compartment as shown
in Figure 2.

Make sure to read the LiPo
Safety Precautions found on
page 12.

Removing the Battery Pack

Remove the battery pack when the
label maker will not be used for more
than seven days.

Make sure the USB cable is disconnected before handling the LiPo
battery pack.

To remove the battery pack

1 Unplug the USB cable.

2 Press and pull to open the side cover of the label maker.

3 Remove the battery pack from the battery compartment.

Make sure to read the LiPo Safety Precautions found on page 12.

3