Duke RBD-60-CP4 Installation Manual

Modular Production Center

RBD-60-TC4 RBD-60-CP4

Installation and

Operation Manual

RBD-60CP4

CAUTION:

RBD-60TC4

Please read this manual completely before attempting to install, operate or service this equipment

Reproduction without written permission is prohibited. Duke is a registered

trademark of the Duke Manufacturing Co.

P/N 529120

REV A Date 08/01/2018

Installation and Operation of: Kool System

CAUTION

TABLE OF CONTENTS

Important Safety Instructions ............................................................................................................................ 2

Critical Daily Startup Guide ................................................................................................................................ 4

Specications ........................................................................................................................................................... 6

Installation ................................................................................................................................................................ 7

Operation .................................................................................................................................................................. 8

Cleaning and Maintenance ................................................................................................................................. 9

Wire Diagram .........................................................................................................................................................10

IMPORTANT SAFETY INSTRUCTIONS

Throughout this manual, you will nd the following safety words and symbols that signify important safety issues with regards to operating or maintaining the equipment.

Indicates a hazardous situation which, if not avoided, could

result in death or serious injury.

Indicates a hazardous situation which, if not avoided, could

result in minor or moderate injury.

Indicates electrical shock hazard which, if not avoided, could

Indicates hot surface which, if not avoided, could result in

Indicates Important Information

result in death or serious injury and/or equipment damage.

minor or moderate injury.

Installation and Operation of: Kool System

In addition to the warnings and cautions in this manual, use the following guidelines for safe operation of the unit.

• Read all instructions before using equipment.

• For your safety, the equipment is furnished with a properly grounded cord connector. Do not attempt to remove or disconnect the grounded connector.

• Install or locate the equipment only for its intended use as described in this manual.

• Do not use corrosive chemicals on this equipment.

• Do not operate this equipment if it has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped.

• This equipment should be serviced by qualied personnel only. Contact the nearest Duke authorized service facility for adjustment or repair.

• Do not block or cover any openings on the unit.

• Do not immerse cord or plug in water.

• Keep cord away from heated surfaces.

• Do not allow cord to hang over edge of table or counter.

The following warnings and cautions appear throughout this manual and should be carefully observed.

• Turn the unit o, disconnect the power source and allow unit to cool down before performing any service or maintenance on the unit.

• The procedures in this manual may include the use of chemical products. You must read the Material Safety Data Sheets before using any of these products.

• The unit should be grounded according to local electrical codes to prevent the possibility of electrical shock. It requires a grounded receptacle with dedicated electrical lines, protected by fuses or circuit breaker of the proper rating, in accordance with all applicable regulations.

• Disposal of the unit must be in accordance with local environmental codes and/or any other applicable codes.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Installation and Operation of: Kool System

CAUTION

INSTALLATION

This equipment is to be installed to comply with applicable Federal, State or Local Plumbing Code.

DRAIN CONNECTION:

The unit is designed to be used with or without a drain hook-up. The drain is supplied with a hose attached for use with a bucket, or may be hooked up to a oor or sink drain. Consult local codes as to the type of drain hook-up required in your area.

The Refrigerated Counter Top is designed to hold pre-chilled products at suitable serving temperature. It is not designed to chill products or store them for long periods of time. Due to the variety of food products served from the efrigerated counter top, they should be stirred periodically to maintain consistent temperature. Foods that are not stirred periodically can become too warm on the top surface and freeze at the bottom. Prior to use, the unit should be turned on to lower the pan temperature before the chilled product is set in place. The unit should shut down daily for defrosting and cleaning.

ELECTRICAL CONNECTIONS:

The unit is designed to be operated on one (1) 15 amp dedicated circuit. The unit must be grounded. The receptacle, wired circuit, and protection should meet the required local codes for proper operation. If the supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or an authorized service company in order to avoid a hazard.

+ 8 hidden pages