Dual XDM265 User Manual

XDM265

INSTALLATION/OWNER'S MANUAL

AM/FM/CD Receiver with Detachable Face

XDM265 INSTALLATION

OR DASHBOARD

Preparation

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove trim ring from unit.

• Remove 2 transit screws located on top of the unit.

• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.

• Install mounting sleeve into opening, bending tabs to secure.

• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.

• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

• Test for correct operation and slide into mounting sleeve to secure.

• Snap trim ring into place.

REMOVAL KEYS

MOUNTING SLEEVE

HEAD UNIT

INSTALLATION

MOUNTING KIT

TYPICAL FRONT-LOAD

DIN MOUNTING METHOD

Rear RCA Preamp Output

Connect to an amplifier input

XDM265 INSTALLATION

Wiring Diagram

Antenna

Connector

10 AMP

AGC Fuse

FUSE

When replacing the fuse,

make sure new fuse is the

correct type and amperage.

Using an incorrect fuse could

damage the radio.

The XDM265 uses one

10 amp AGC fuse located

in-line.

XDM265 OPERATION

Control Locations

1 2 3 4 5

19 7

Release

1 11

Band / Go Back

2 12

Volume Knob

3 13

Power

4 14

14 13 12 11 10 9 81718

1516

Preset 3 / Intro

Preset 2 / Random

Preset 1 / Repeat

Display

5 15

Eject

USB Port

6 16

Auxiliary Input

7 17

Preset 6 / Folder Up

8 18

Preset 5 / Folder Down

Preset 4 / Play / Pause

Tune / Track Up

Tune / Track Down

Mode

Audio / Menu

Mute

XDM265 OPERATION

General Operation

Faceplate Removal

Power On/Off

Mode

Auxiliary Input

Volume

Display

Reset

Set the Clock

12/24-hour Clock

Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.

Press or any other button (except EJECT) to turn the unit on. Press to turn the unit off.

Press MODE to select between AM/FM, CD player, auxiliary, USB and SD card. Modes of operation are shown in the display.

NOTE: CD and USB modes will not appear unless a CD is inserted or USB device is connected.

The XDM265 offers a 3.5 mm auxiliary input port on the front panel of the unit for connecting an audio device, MP3 player, etc. Press MODE to select auxiliary input mode.

Adjust volume using volume knob (00-47).

Press DISP to show the clock. During playback of MP3/WMA files, ID3 tag information, elapsed time, track number and file/folder names will automatically rotate on the display.

Press RESET upon initial installation or if abnormal operation occurs. Reset button is located behind the front panel.

With the unit on, press and hold DISP until the clock begins to flash, then release. Turn the volume knob to the right to adjust the hours or to the left to adjust the minutes.

The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).

Setup Menu

Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu. Press AUDIO/MENU momentarily to select between the menu functions and rotate the volume knob left/right to adjust or activate the desired function.

XDM265 OPERATION

General Operation - Setup Menu

Menu Function Options Action

Auto Station

Store

Local/Distance

Tuning

Tuner

Frequency

Spacing

Auxiliary

Input

Beep

Confirmation

Programmable

Turn On Volume

Power on

Message

Scrolling

Option

Demonstration

Mode

AUTO STORE

LOCAL OFF Activates distance tuning (Tuner mode only).

LOCAL ON

FREQ USA

FREQ EURO

AUX ON Enables the front panel 3.5mm auxiliary input.

AUX OFF Disables the front panel 3.5mm auxiliary input.

BEEP OFF Disables the confirmation beep.

BEEP ON Enables the confirmation beep.

PRO-VOL #

MSG OFF Disables power on message. (example: GOOD MORNING)

MSG ON Enables power on message to be displayed.

SCROLL 15 S

SCROLL ONCE

SCROLL ON Programs unit to scroll continuously.

SCROLL OFF Programs unit to show the first 10 characters on the display.

DEMO OFF Disables the demonstration mode.

DEMO ON Enables the demonstration message.

Press SELECT to seek and save 6 strong stations in the current band. (Tuner mode only)

Activates local tuning for strong station reception only (Tuner mode only).

Programs the unit to USA tuner spacing. (200kHz for FM and 10kHz for AM). (Tuner mode only)

Programs the unit to European tuner spacing. (50kHz for FM and 9kHz for AM). (Tuner mode only)

Programs unit to always turn on at a specific volume (default is OFF). Any volume level 1-46 can be selected.

Programs unit to scroll information once every 15 seconds (default).

Programs unit to scroll once, then show the first 10 characters on display.

+ 14 hidden pages