Page 1
XD5120
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver
Page 2
XD5120 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for
instructions.
• Avoid installing the unit where it would be subject to high temperatures,
such as from direct sunlight, or where it would be subject to dust, dirt or
excessive vibration.
Getting Started
• Remove 2 transit screws located on top of the unit.
• Remove trim ring by pulling up gently in the center.
• Insert the supplied keys into the slots as shown, and slide the unit out of the
mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you
are unsure.
• Certain vehicles may require an installation kit and/or wiring harness
adapter (sold separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
2
Page 3
XD5120 INSTALLATION
Installation
TYPICAL MOUNTING METHOD
3
Page 4
XD5120 INSTALLATION
Diagram
FUSES
When replacing fuses,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD5120 uses one 7
amp AGC fuse (Battery),
one 0.5 amp AGC fuse
(Ignition) and one 0.5 amp
AGC fuse (Remote Turn-on)
located in-line.
* Caution - Do not attach any speaker leads to ground as severe damage will occur.
4
Wiring
Page 5
XD5120 OPERATION
Control Locations
1
2
3
4
5 6
16
17
1
Release
2
Power
3
Band
4
Audio
5
Volume Up
6
Eject
7
Volume Down
Track Up
8
Track Down
9
10
11
12
13
14
15
10
Play/Pause
11
Loudness/CD Random
12
Local/Distance/CD Repeat
13
Mono/Stereo/CD Intro
14
Mute
15
EQ
Display
16
Tuning
17
8
9
7
5
Page 6
XD5120 OPERATION
General Operation
Faceplate Removal
Power On/Off
CD Mode
Tuner Mode
Loudness
Volume
Mute
Display
6
Press RELEASE and pull away from the left side to
remove. To re-install, insert right side of faceplate first
then push left side to secure.
Press POWER to turn the unit on. Inserting a CD will
turn the unit on automatically. Press POWER to turn the
unit off.
Insert a CD or press l/ II to begin or resume
playback.
Press POWER or BAND to begin or resume tuner
operation.
Press LOUD to activate and deactivate bass boost
curve. Activating this feature will enhance the bass
frequencies when listening to music at all volumes.
Adjust volume using VOL + or VOL - (0-63).
Press MUTE to silence the audio.
Press MUTE again to cancel.
Press DISP to display the clock. The radio frequency
(tuner mode) or CD elapsed time/track (CD player
mode) show by default.
Page 7
XD5120 OPERATION
BASSVOLUME
TREBLE BALANCE F
ADER
General Operation
Set the Clock
Preset EQ Curves
Audio
Bass
Treble
Balance
Fader
Press and hold DISP until the clock begins to flash,
then release. Press TRACK to adjust the hours
and TRACK to adjust the minutes. Press DISP
momentarily to save the selected time.
Press EQ to select between POP, CLASSIC, ROCK
and OFF (default) equalization curves. The Bass and
Treble settings are not adjustable when an EQ curve
is selected.
Press AUD to select between Volume (default), Bass,
Treble, Balance & Fader.
Press AUD until BAS appears
Press VOL - or + to adjust
(-7 minimum / 7 maximum)
Press AUD until TRE appears
Press VOL - or + to adjust
(-7 minimum / 7 maximum)
Press AUD until BAL appears
Press VOL - (LEFT) or + (RIGHT) to adjust
(BA.L 10/BA.R 10) BAL 0 represents equal balance.
Press AUD until FAD appears
Press VOL - (FRONT) or + (REAR) to adjust
(FA.F 10/FA.R 10) FAD 0 represents equal fader.
7
Page 8
XD5120 OPERATION
Tuner Operation
FM Mono/Stereo
Local/Distance
8
Tuning
Band
Turn TUNE knob to select desired station.
Press MONO during FM tuner operation to select mono
or stereo (default) reception of the broadcast signal.
Press LOC during FM tuner operation to activate local
tuning for strong station reception only. Press LOC
again to cancel and resume Distance tuning (default).
Press BAND to select between FM and AM bands.
Page 9
XD5120 OPERATION
CD Player Operation
Insert CD
Eject CD
Track Select
Fast Forward
and Reverse
Pause
Intro
Repeat
Random
CD-R/CD-RW
Compatibility
With the label facing up, insert a disc into the CD slot.
The CD will automatically begin playback.
Press the EJECT button to stop and eject the CD.
The unit will change to tuner mode. If the disc is not
removed within 10 seconds, the unit will reload the
disc.
Press TRACK to skip to the beginning of the next
track. Press TRACK to return to the beginning of
the current track. Pressing TRACK again skips to
the beginning of the previous track.
Press and hold TRACK or TRACK to fast
forward or reverse a track.
Press l/ II to temporarily stop CD playback.
Press l/ II again to resume playback.
Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Press RPT to continuously repeat selected track.
Press RPT to cancel.
Press RDM for more than 2 seconds to play all tracks
in random order. Press RDM again for more than 2
seconds to cancel.
Some CD-Rs and CD-RWs may be incompatible with
this unit, depending on media type and recording
method.
9
Page 10
XD5120 WARRANTY
Limited One Year Warranty
This warranty gives you specific legal rights.
You may also have other rights which vary from
state to state.
Dual Electronics Corp. warrants this product to
the original purchaser to be free from defects in
material and workmanship for a period of one
year from the date of the original purchase.
Dual Electronics Corp. agrees, at our option,
during the warranty period, to repair any defect
in material or workmanship or to furnish an
equal new, renewed or comparable product
(whichever is deemed necessary) in exchange
without charges, subject to verification of the
defect or malfunction and proof of the date of
purchase. Subsequent replacement products
are warranted for the balance of the original
warranty period.
Who is covered? This warranty is extended to
the original retail purchaser for products
purchased and used in the U.S.A.
What is covered? This warranty covers all
defects in material and workmanship in this
product. The following are not covered:
installation/removal costs, damage resulting
from accident, misuse, abuse, neglect, product
modification, improper installation, incorrect
line voltage, unauthorized repair or failure to
follow instructions supplied with the product,
or damage occurring during return shipment
of the product.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship
it by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
• Call us toll-free at 1-866-382-5476
• E-mail us at cs@dualav.com
Exclusion of Certain Damages: This warranty
is exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right,
claim or remedy in contract or tort, whether
or not arising from the company’s negligence,
actual or imputed. No person or representative
is authorized to assume for the company any
other liability in connection with the sale of
this product. In no event shall the company be
liable for indirect, incidental or consequential
damages.
10
Page 11
XD5120 OPERATION
Specifications
CD Player
FM Tuner
AM Tuner
General
Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >50dB
D/A converter: 1 Bit
Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 15dBf
50dB quieting sensitivity: 23dBf
Stereo separation @ 1kHz: 25dB
Frequency response: 80Hz-10kHz
Tuning range: 530kHz-1720kHz
AM sensitivity: 30uV
Frequency response: 80Hz-1.8kHz
Operating voltage: 11-16 VDC, negative ground
Speaker output impedance: 4~8 ohms
Fuses: 0.5 amp fast blow AGC, 7 amp fast blow AGC
Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)
Design and specifications subject to change without notice.
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to Noise Ratio: 65dBA (reference: 1 watt into 4 ohms)
11
Page 12
XD5120 OPERATION
Troubleshooting
Problem Cause Action
Unit will not
turn on
(no power)
Unit has power
(but no sound)
Unit blows
fuses
Excessive
skipping
Err appears on
display
Yellow or red wire not connected or
incorrect voltage
Black wire not connected Check connection to ground
Fuse blown Replace fuse
Speaker wires not connected Check connections at speakers
One or more speaker wires touching
each other or touching chassis
ground
Yellow or red wire touching chassis
ground
Speaker wires touching chassis
ground
Incorrect fuse rating Use fuse with correct rating
Unit is not mounted correctly or
backstrap is not secure
Physical defect in media
(CD, CD-R or CD-RW)
Load/Eject operation error or disc is
in upside down
Check connections for proper
voltage (11~16VDC)
Insulate all bare speaker wires
from each other and chassis
ground
Check for pinched wire
Check for pinched wire
Check mounting sleeve and
backstrap support
Check media for scratches
Press eject
Dual Electronics Corp.
Toll Free: 1-866-382-5476
©2006 Dual Electronics Corp. All rights reserved.
www.dualav.com
NSA0806-V01
Loading...