Please read these instructions carefully and follow all instructions, guidelines, and warnings included in this product manual in order to ensure
that you install, use, and maintain the product properly at all times. These instructions MUST stay with this product.
By using the product, you hereby confirm that you have read all instructions, guidelines, and warnings carefully and that you understand and
agree to abide by the terms and conditions as set forth herein. You agree to use this product only for the intended purpose and application
and in accordance with the instructions, guidelines, and warnings as set forth in this product manual as well as in accordance with all applicable laws and regulations. A failure to read and follow the instructions and warnings set forth herein may result in an injury to yourself and
others, damage to your product or damage to other property in the vicinity. This product manual, including the instructions, guidelines, and
warnings, and related documentation, may be subject to changes and updates. For up-to-date product information, please visit
dometic.com.
Safety instruction: Indicates a hazardous situation that, if not avoided,
could result in death or serious injury.
CAUTION!
Safety instruction: Indicates a hazardous situation that, if not avoided,
could result in minor or moderate injury.
EN
MoBar300S/550SSafety instructions
NOTICE!
A
I
Indicates a situation that, if not avoided, can result in property damage.
NOTE
Supplementary information for operating the product.
2Safety instructions
WARNING! Failure to obey these warnings could result in death
or serious injury.
!
Electrocution hazard
• Do not operate the device if it is visibly damaged.
• If this cooling device's power cable is damaged, it must be replaced
by the manufacturer, a service agent or a similarly qualified person in
order to prevent safety hazards.
• This device may only be repaired by qualified personnel. Improper
repairs can lead to considerable hazards.
• The cooling device is only completely insulated from the electricity
supply when the following applies:
– The device has been unplugged.
– The mains fuse has been switched off.
• lmproper use of the grounded plug can result in the risk of electrical
shock. This appliance should be properly grounded for your safety.
The power cord of this device is equipped with a three-prong plug
which mates with standard three-prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third (ground)
prong from the power cord supplied. For personal safety, this device
must be properly grounded.
• Do not splash water on the applicance. It may cause electrical parts to
fail and result in electric shock.
Fire hazard
• When positioning the device, ensure the supply cord is not trapped or
damaged.
• Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the device.
17
EN
Safety instructionsMoBar300S/550S
• Do not use any mechanical objects or other media to speed up the
defrosting process, unless they have been recommended by the
manufacturer for this purpose.
• Do not damage the refrigerant circuit.
In any case of damage:
– Disconnect the device from the power supply.
– Avoid open flames and anything which creates sparks.
• Leaking refrigerant can form a flammable gas-air mixture in rooms
which are too small.
Health hazard
• This device can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or
instruction concerning use of the device in a safe way and understand
the hazards involved.
• Children shall not play with the device.
• Cleaning and user maintenance shall not be made by children without
supervision.
• Children aged from 3 to 8 years are allowed to load and unload
refrigerating devices.
Explosion hazard
• Do not store any explosive substances such as spray cans with a
flammable propellant in the cooling device.
Danger of sparks and explosion
• Do not use any electrical equipment inside the storage compartments
of the device unless they are of the type recommended by the manufacturer.
!
18
CAUTION! Failure to obey these cautions could result in minor or
moderate injury.
Electrocution hazard
• Before starting the cooling device, ensure that the power supply line
and the plug are dry.
• Disconnect the cooling device from the power supply
– before each cleaning and maintenance
– after every use
Health hazard
• Opening the cooling device for long periods can cause significant
increase of the temperature in the compartments of the device.
EN
MoBar300S/550SSafety instructions
• Clean regularly surfaces that can come in contact with food and
accessible drainage systems.
NOTICE! Damage hazard
A
• Check that the voltage specification in t his man ual cor res pon ds t o th at
of the energy supply. This data must correspond in order to avoid the
risk of damage to the device. Consult a qualified electrician if in any
doubt.
• Do not use a steam-cleaning device to clean the device. Steam could
reach the electrical components and cause a short circuit.
• Avoid locating the device in damp areas.
• Connect the cooling device with an AC connection cable to the AC
power supply.
• Never pull the plug out of the socket by the cable.
• Do not use accessories that have not been recommended by the
manufacturer. This can lead to injury and material damage.
• Do not lean on the device.
• Do not climb onto the device.
• Do not tilt the device, especially when it is fully loaded.
• Locate the device away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating
and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the device not to perform
properly.
• During periods of high humidity, some condensation may appear on
outside surface of glass door. This condensation will disappear when
humidity levels drop.
• Before first use clean the inside of the cooling device (see chapter
“Cleaning and maintenance” on page 27). Wait for 1 – 1.5 hours after
placing the appliance in its final position to allow the refrigerant to
settle before connecting it to the mains power supply.
19
EN
Scope of deliveryMoBar300S/550S
3Scope of delivery
3.1MoBar300S
Item in
fig. 1, page 3
1Beverage center MoBar51SZAC1
2Extension table1
3Speed rail1
4Cutting board1
5Towel bar handle1
6Key2
DescriptionQuantity
3.2MoBar550S
Item in
fig. 2, page 4
1Beverage center MoBar100DZAC1
2Serving tray1
3Cutting board1
4Speed rail1
5Fresh ice and garnish container1
6Towel bar handle1
7Key2
DescriptionQuantity
20
EN
MoBar300S/550SAccessories
4Accessories
Available as accessories (some included in scope of delivery):
DescriptionRef. no.
Speed rail MoBar 300/550 SR9600028661
Extension table including cutting board MoBar 300/550 EXT9600028665
Protective covers MoBar300 PC9600028673
Protective covers MoBar550S PC9600028675
Cutting board MoBar CB9600028667
Serving tray MoBar ST9600028669
Fresh ice and garnish container MoBar FIC9600029365
If you have questions regarding the accessories, contact your local service partner.
5Intended use
The beverage storage appliance (also referred to as beverage center) is intended to
be used exclusively for the storage and temperature control of beverages. It is suitable as mobile outdoor beverage center.
This beverage center is not intended to be used as a built-in appliance.
The beverage center is intended to be used for the storage of beverages.
• Only closed and still sealed bottles may be stored in the device.
• The beverage center is not suitable for storing medicine or freezing foodstuffs.
This beverage center is only suitable for the intended purpose and application in
accordance with these instructions.
This manual provides information that is necessary for proper installation and/or
operation of the beverage center. Poor installation and/or improper operating or
maintenance will result in unsatisfactory performance and a possible failure.
The manufacturer accepts no liability for any injury or damage to the product
resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts
provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
21
Loading...
+ 49 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.