S
Visit DOD on the World Wide Web at http://www.dod.com
SR 400D manual 6/8/99 10:54 AM Page 1
Harman Music Group Inc.
IMPORTANT!
FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool, etc). Care should be taken so that objects do not fall on and liquids are not spilled into the enclosure through
openings.
POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as
marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
SERVICING: The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing
should be referred to qualified service personnel.
FUSING: If your unit is equipped with a fuse receptacle, replace with only same type fuse. Refer to replacement text on the unit for correct
fuse type.
Warranty
1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty.
2. DOD warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship
under normal use and service.
3. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to
a period of two (2) years. A Return Authorization number may be obtained from DOD by telephone. The company shall
not be liable for any consequential damage as a result of the product’s use in any circuit or assembly.
4. Proof-of-purchase is considered to be the burden of the consumer.
5. DOD reserves the right to make changes in design or make additions to or improvements upon this product without
incurring any obligation to install the same on products previously manufactured.
6. The foregoing is in lieu of all other warranties, expressed or implied, and DOD neither assumes nor authorizes any person to assume for it any obligation or liability in connection with the sale of this product. In no event shall DOD or its
dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control.
DOD® and SR 400 D™ are registered trademarks of DOD Electronics Corporation.
The information contained in this manual is subject to change at any time without notification. Some information contained
in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of
the manual was completed. The information contained in this version of the owner's manual supersedes all previous versions.
SR 400D manual 6/8/99 10:54 AM Page 2
Table of Contents
Warranty ..........................................................................................................................................................iv
Introduction ....................................................................................................................................................2
Safety Precautions............................................................................................................................................2
SECTION 1 - GETTING STARTED ................................................................................................................3
Supplying Power..............................................................................................................................................3
Front Panel Controls ....................................................................................................................................3
Bypass Button ..................................................................................................................................................3
Mode Button....................................................................................................................................................3
Utility Button....................................................................................................................................................4
Display Window ..............................................................................................................................................4
Signal / Clip LEDs ............................................................................................................................................4
Level Button ....................................................................................................................................................4
Store Button ....................................................................................................................................................4
Delay 1 ............................................................................................................................................................4
Delay 2 ............................................................................................................................................................4
Data Wheel ......................................................................................................................................................4
Channel 1 Knob ..............................................................................................................................................4
Channel 2 Knob ..............................................................................................................................................4
Rear Panel Connections................................................................................................................................4
Channel 1 / XLR Input ....................................................................................................................................4
Barrier Strip Input Connection ......................................................................................................................4
Channel 2 XLR Input ......................................................................................................................................5
Channel 1 XLR Output ....................................................................................................................................5
Barrier Strip Output Connection ....................................................................................................................5
Channel 2 XLR Output ....................................................................................................................................5
Power Adapter Input........................................................................................................................................5
SECTION 2 - PROGRAMMING SR 400 D ....................................................................................................5
Selecting and Editing Delays............................................................................................................................5
Temperature ....................................................................................................................................................5
Humidity ..........................................................................................................................................................5
Storing Programs..............................................................................................................................................5
Mode ................................................................................................................................................................6
Bypassing the SR 400 D's Programs ................................................................................................................6
SECTION 3- THE UTILITY MENU ................................................................................................................6
Key Lock ..........................................................................................................................................................6
Temperature Unit Selection ............................................................................................................................6
LCD Contrast....................................................................................................................................................6
Humidity ..........................................................................................................................................................6
Temperature ....................................................................................................................................................7
Factory Reset....................................................................................................................................................7
Specifications ..................................................................................................................................................7
1
SR 400D manual 6/8/99 10:54 AM Page 1
Signal Processing
Loading...