DOD Rubberneck Data Sheet

Rubberneck

HOW IT WORKS:

Analog Delay

|

Time Knob:

This knob controls the delay
time. Range is 30ms to
1000ms. Up to 1500ms of
delay is available using the
Tempo footswitch.

Rate/Depth
Knobs:

These knobs control
the amount of delay
time modulation
creating sounds from
subtle chorusing to
wild vibrato/tremolo
textures.

Tap Ratio Switch:

This switch selects
between 3 dierent
tempo ratios making
it easy to get delay
repeats that are
perfectly in time with
the tapped intervals or
giving them a triplet or
doubled feel.

Repeats Knob:

This knob controls number of
delay repeats heard. Higher
settings can create oscillating
runaway feedback that analog
delays are known for.

Level Knob:

This knob controls the output
level of the delay signal. Use
this in conjunction with the
Repeats, Tone and Gain knobs
to balance your delay levels.

Gain/Tone Knobs:

The Gain knob shapes
the delay signal by
adding more input
gain into the bucket
brigades making the
delay more overdriven.
The Tone knob
increases brightens
or darkens the delay
signal.

Tails Switch:

This switch allows
repeats to be heard or
not heard when the
delay is bypassed. The
3rd option (On-No Dry)
defeats the dry signal
while allowing delay
repeats to continue in
bypass.

Eect On
Footswitch:

This footswitch turns the
delay eect on and o.
When this footswitch
is pressed and held the
Rubbernecking feature is
enabled which modies
the delay time up or
down at dierent rates
depending on the setting
of the Rubberneck Rate
control.

Eect LED/Rubberneck
Rate Control:

This transparent pot utilizes a
bi-color LED beneath it to indicate
dierent delay operating states.
When it is green the delay eect
is enabled. When it is pulsing
green to yellow it is enabled and
showing the modulation Rate and
Depth settings. When it is red the
Rubbernecking feature is active.
The pot itself is used for selecting
the Rubberneck rate (time it takes
to modify the delay time when
the Eect footswitch is pressed
and held).

Tempo LED/Regen
Adjust Control:

This transparent pot utilizes
an LED beneath it that ashes
at the current delay time. The
delay time can be changed
by tapping the Tempo/
Regen footswitch. The pot
itself is used for adjusting
the secondary regen/repeats
setting of the delay that is
enabled by pressing and
holding the Tempo/Regen
footswitch.

Placement of the Rubberneck:
Rubberneck can be placed anywhere in
the signal path but it is recommended
as the last eect in the signal chain.

Tempo/Regen
Footswitch:

This footswitch is used
to tap in the delay time
during performance.
When the delay is
enabled and the
footswitch is pressed, it
enables the secondary
repeats regen control
in the path providing
control of a secondary
delay repeats setting
set by the Regen Adjust
control.